Pulse radiolysis water

Guldi D M 1997 Capped fullerenes stabilization of water-soluble fullerene monomers as studied by flash photolysis and pulse radiolysis J. Phys. Chem. A 101 3895-900... 

It is pertinent that S20g accepts an electron generated by pulse radiolysis of water to give optically detectable S04 within 1.5 x 10 sec . ... 

In general, reduction potentials of nucleobases have been studied much less than their oxidation potentials, and in particular water-based data are rather lacking [2, 35]. We therefore listed the available polarographic potentials measured in dimethylformamide and data obtained from pulse radiolysis studies or fluorescence quenching measurements. From the data in Table 1, it is evident that the pyrimidine bases are most easily reduced. The reduction potential of the T=T CPD lesion is close to the estimated value of the undamaged thymine base [34, 36]. 

Both CO and C02 are reduced by eh. The immediate product of the first reaction is CO-, which reacts with water, giving OH and the formyl radical the latter has been identified by pulse radiolysis. The product of carbon dioxide reduction, C02-, is stable in the condensed phase with an absorption at 260 nm. It reacts with various organic radicals in addition reactions, giving carboxylates with rates that are competitive with ion-ion or radical-radical combination rates. 

Bobrowski and Das33 studied the transient absorption phenomena observed in pulse radiolysis of several retinyl polyenes at submillimolar concentrations in acetone, n -hexane and 1,2-dichloroethane under conditions favourable for radical cation formation. The polyene radical cations are unreactive toward oxygen and are characterized by intense absorption with maxima at 575-635 nm. The peak of the absorption band was found to be almost independent of the functional group (aldehyde, alcohol, Schiff base ester, carboxylic acid). In acetone, the cations decay predominantly by first-order kinetics with half life times of 4-11 ps. The bimolecular rate constant for quenching of the radical cations by water, triethylamine and bromide ion in acetone are in the ranges (0.8-2) x 105, (0.3-2) x 108 and (3 — 5) x 1010 M 1 s 1, respectively. 

The one-electron reduction potentials, (E°) for the phenoxyl-phenolate and phenoxyl-phenol couples in water (pH 2-13.5) have been measured by kinetic [pulse radiolysis (41)] and electrochemical methods (cyclic voltammetry). Table I summarizes some important results (41-50). The effect of substituents in the para position relative to the OH group has been studied in some detail. Methyl, methoxy, and hydroxy substituents decrease the redox potentials making the phe-noxyls more easily accessible while acetyls and carboxyls increase these values (42). Merenyi and co-workers (49) found a linear Hammett plot of log K = E°l0.059 versus Op values of substituents (the inductive Hammett parameter) in the 4 position, where E° in volts is the one-electron reduction potential of 4-substituted phenoxyls. They also reported the bond dissociation energies, D(O-H) (and electron affinities), of these phenols that span the range 75.5 kcal mol 1 for 4-amino-... 

The generation of HO by pulse radiolysis provides a way for investigating the kinetics of hydroxyl spin adduct formation. For PBN and some of its 4-substituted derivatives (ranging from 4-MeO to 4-N02), rate constants in the range of (5-9) X 109 dm3 mol 1 s 1 were determined (Greenstock and Wiebe, 1982). A study of the reaction of the water-soluble 2-, 3- and 4-PyBN[23] and HO showed that most of the hydroxyl radicals became attached to the heteroaromatic ring (Neta et al., 1980 Sridhar et al., 1986). Similar findings... 

The absence of dimer radical cation formation by diphenyl selenide under the pulse radiolysis conditions is in contrast to bimolecular reactions believed to occur under electrochemical conditions/ In these experiments, a rotating disk electrode was used in combination with commutative voltammetry under anhydrous conditions. The results led to the conclusion that reversible one-electron oxidation is followed by disproportionation, then reaction of the resulting dication with diphenyl selenide or an external nucleophile, with the likely intermediacy of the dimer dication (Fig. 33). As expected, the dihydroxy selenane is formed when water is present. Based on the kinetics of the electrochemical reaction, the authors believe the diselenide dication, not the radical cation, to be the intermediate that reacts with the nucleophile. 

The second-order rate constant for oxidation of Fe(CN)g by OH" radicals, produced by low-intensity-pulse radiolysis of water, varies with pH as in the accompanying table. Determine the pA for acid dissociation of the OH" radical in aqueous solution. (This is difficult to obtain by any other method.)... 

Aromatic radical-cations are generated by pulse-radiolysis of benzene derivatives in aqueous solution. Radiolysis generates solvated electrons, protons and hydroxyl radicals. The electrons are converted by reaction with peroxydisulpbate ion to form sulphate radical-anion, which is an oxidising species, and sulphate. In another proceedure, electrons and protons react with dissolved nitrous oxide to form hydroxyl radicals and water, Hydroxyl radicals are then made to react with either thallium(i) or silver(i) to generate thallium(ii) or silver(ll) which are powerfully... 

Table 6.2. Long wavelength uv absorption bands of benzene radical-cations in water, determined by pulse-radiolysis techniques.

A third important reaction of aromatic radical-cations is carbon-carbon bond formation with a further aromatic substrate. This reaction is limited to the oxidation in acetonitrile of substrates with electrondonating substituents. Radical-cations from benzene, naphthalene and anthracene form a-complexes but do not form a a-bonded reaction intermediate. Tlie dimerization reaction has been investigated both by pulse-radiolysis [22] in water and by electrochemical methods [27] in acetoni-... 

Figure 8 The time-dependent behavior of the hydrated electron obtained in the subpicosecond pulse radiolysis of neat water using 2-mm optical path sample cell, monitored at the wavelength of 780 nm.

Shortly after the discovery of the hydrated electron. Hart and Boag [7] developed the method of pulse radiolysis, which enabled them to make the first direct observation of this species by optical spectroscopy. In the 1960s, pulse radiolysis facilities became quite widely available and attention was focussed on the measurement of the rate constants of reactions that were expected to take place in the spurs. Armed with this information, Schwarz [8] reported in 1969 the first detailed spur-diffusion model for water to make the link between the yields of the products in reaction (7) at ca. 10 sec and those present initially in the spurs at ca. 10 sec. This time scale was then only partially accessible experimentally, down to ca. 10 ° sec, by using high concentrations of scavengers (up to ca. 1 mol dm ) to capture the radicals in the spurs. From then on, advancements were made in the time resolution of pulse radiolysis equipment from microseconds (10 sec) to picoseconds (10 sec), which permitted spur processes to be measured by direct observation. Simultaneously, the increase in computational power has enabled more sophisticated models of the radiation chemistry of water to be developed and tested against the experimental data. 

The time dependence of the yield of hydrated electrons during the chemical stage of water radiolysis (ca. 10 to 10 sec) can be obtained from scavenging studies and by direct observation using pulse radiolysis. In the former case, the scavenger dependence G(S) is converted into the time dependence using the inverse Laplace transform of F(S) to F(t), which is given by Eqs. (19) and (20) ... 

Although its precise structure has not yet been settled, the hydrated electron may be visualized as an excess electron surrounded by a small number of oriented water molecules and behaving in some ways like a singly charged anion of about the same size as the iodide ion. Its intense absorption band in the visible region of the spectrum makes it a simple matter to measure its reaction rate constants using pulse radiolysis combined with kinetic spectrophotometry. Rate constants for several hundred different reactions have been obtained in this way, making kinetically one of the most studied chemical entities. 

Generally, the reduction is achieved under deaerated conditions to avoid a competitive scavenging of Cjoiv and H atoms by oxygen. These atoms are as homogeneously distributed as the ions and the reducing species, and they are therefore produced at first as isolated entities. Similarly, multivalent ions are reduced by multistep reactions, including disproportionation of intermediate valencies. Such reduction reactions have been observed directly by pulse radiolysis for a variety of metal ions (Fig. 2), mostly in water [28], but also in other solvents where the ionic precursors are soluble. Most of their rate eonstants are known and the reactions are often diffusion controlled. 

---