Powder charging particle size

Stricter control of particle size distribution improves powder handling (qv) and transport through the system, and appHcation efficiency. It also reduces blinding of the final filter (69). Additives have been developed which improve the triboelectric charging characteristics (70). 

Based on available results, it can be summarized that the particle size of tantalum powder increases (specific charge decreases) with the increase in temperature, K2TaF7 concentration and excess sodium. In addition, an increase in the specific surface area of the melt and Na/K ratio also leads to the formation of coarser tantalum powder. The most important conclusion is that for the production of finer tantalum powders with higher specific charges, the concentration of K2TaF7 in the melt must be relatively low. This effect is the opposite of that observed in the electrochemical reduction of melts. 

Figure 20. Cycling behavior of Sn+SnSb powder (analytical composition "SnassSb(U2particle size <0,2pm) and Sn powder (particle size

Table I lists a variety of organic nonlinear materials which have appeared in the literature their relative powder efficiencies, absorption cutoffs and /3 values (if available) are also provided. These materials are "typical" only in that they represent results from the few classes of organic compounds investigated to date, yet they are instructive in that one learns which molecular properties may be important. A few caveats are in order to avoid misinterpretation of the data in Table I. Except for compound 10 (19) all the powder efficiency and cutoff data are from our own measurements. Powder measurements were performed on ungraded samples using the Nd YAG output at 1.06/t as fundamental since powder efficiency is a function of particle size distribution and a variety of other factors (3) these values are only semiquantitative. The cutoff values are the wavelengths for which 10-4M solutions in ethanol (unless otherwise indicated) have no absorbance. The cutoff values will be similar to those found in crystal state except where intermolecular charge transfer is important in the crystal or the molecule is solvatochromic, this latter effect being quite common for cyanine dyes such as...

Fig. 3. Like a photoelectrochemical cell, such a powder includes sites for photo-induced oxidation and reduction, but no external current flow accompanies these transformations. Photoactivity is also maintained as the size of the particle decreases to the colloidal range although the absorption characteristics, the quantum efficiency of charge separation, and the kinetics of interfacial electron transfer may be influenced by the particle size. On sufficiently small particles, for example, the calculated space-charge width necessary for effective band bending may exceed the dimensions of the particle.

---