Polyurethanes soft segments used

The hydroxyl groups can be esterified normally the interesting diacrylate monomer (80) and the biologicaky active haloacetates (81) have been prepared in this manner. Reactions with dibasic acids have given polymers capable of being cross-linked (82) or suitable for use as soft segments in polyurethanes (83). Polycarbamic esters are obtained by treatment with a diisocyanate (84) or via the bischloroformate (85). 

The melt temperature of a polyurethane is important for processibiUty. Melting should occur well below the decomposition temperature. Below the glass-transition temperature the molecular motion is frozen, and the material is only able to undergo small-scale elastic deformations. For amorphous polyurethane elastomers, the T of the soft segment is ca —50 to —60 " C, whereas for the amorphous hard segment, T is in the 20—100°C range. The T and T of the mote common macrodiols used in the manufacture of TPU are Hsted in Table 2. 

One partieular form of thermoplastic polyurethane elastomers is the elastic fibre known as spandex fibre. Like the usual thermoplastic rubbers these materials consist of hard and soft segments but to qualify for the term spandex by the US Federal Trade Commission the polymer used should contain at least 85% of segmented polyurethane. The first commercial material of this type was introduced by Du Pont in 1958 (Lycra). Several other similar materials have since been introduced including Dorlastan (Bayer), Spanzelle (Courtaulds) and Vyrene (US Rubber). 

In an NMR analysis of the effects of /-irradiation induced degradation on a specific polyurethane (PU) elastomer system, Maxwell and co-workers [87] used a combination of both H and 13C NMR techniques, and correlated these with mechanical properties derived from dynamic mechanical analysis (DMA). 1H NMR was used to determine spin-echo decay curves for three samples, which consisted of a control and two samples exposed to different levels of /-irradiation in air. These results were deconvoluted into three T2 components that represented T2 values which could be attributed to an interfacial domain between hard and soft segments of the PU, the PU soft segment, and the sol... 

Owing to their improved stability towards hydrolysis and oxidation, dimer diol polyethers (and dimer diol polycarbonates) are used as soft segments in the preparation of thermoplastic polyurethanes. Polyurethanes prepared from such oleo-chemical building blocks are very hydrophobic and show the expected stability. 

Polyurethane hydrogels derived from UV curable urethane prepolymer and hydrophilic monomers were prepared and their properties were evaluated. The urethane prepolymer used in this study contained well-defined hard segments centered with a polyether-based soft segment and end-capped with methacrylate groups. The hydrophilic monomers studied were 2-hydroxyethyl methacrylate (HEMA), N-vinyl pyrrolidone, and glycerol methacrylate. Methacryloxypropyl tris(trimethysiloxy) silane (TRIS) was also used in some cases to modify properties. All compositions were UV... 

Elastomeric, lignin-derived polyurethanes can be produced from a three-component system, in which a polyether diol (like PEG) is used as soft segment, provided that the crosslink density is held at a low level and that the soft segment content is high enough to keep T below room temperature. 

Various x-ray diffraction techniques have been used to study the size and distribution of hard and soft segments near the surface of the polyurethane. 

---