Plant sublimation rate

Table maximum water vapor flow-rates given by the hydrodynamic data of the plant. The maximum sublimation rates depend also on the heat transfer from the brine to the sublimation front of the ice [see Eq. (12)]. The main drying time will generally be governed above 0.06 mbar by the heat transfer and below 0.06 mbar by the water vapor transport, as shown in the example below ... 

LRmax maximum tolerable leak rate of a plant LS sublimation energy of water... 

Quenching the vapour with cold air in the chamber may increase the rate of heat removal although excessive nucleation is likely and the product crystals will be very small. Condenser walls may be kept free of solid by using internal scrapers, brushes, and other devices, and all vapour lines in sublimation units should be of large diameter, be adequately insulated, and if necessary, be provided with supplementary heating to minimise blockage due to the buildup of sublimate. One of the main hazards of air-entrainment sublimation is the risk of explosion since many solids that are considered safe in their normal state can form explosive mixtures with air. All electrical equipment should therefore be flame-proof, and all parts of the plant should be efficiently earthed to avoid build-up of static electricity. 

The other vapor-phase butane isomerization process, developed cooperatively by the Anglo-Iranian Oil Co. and the Standard Oil Development Co., is somewhat similar to the Isocel process. In the AIOC-Jersey process (18), the reactor is initially filled with bauxite, and aluminum chloride is sublimed into the vaporized feed as necessary to maintain the desired catalyst activity. Upflow of vapor through the reactor is the customary arrangement. Since carry-over of aluminum chloride is not excessive at the usual rates of catalyst addition, about half of the commercial plants employing this process were not equipped with guard chambers. 

---