Path-type

Element Analyt- ical Line Wavelength, A Crystal Slit Width, in. Path Type of Detector Detector Path Length, cm Detector Window"... 

DESCRIPTION>Low Normal Lab Value Range/NORMALS/ROW/Low Normal numeric... 

From a chemical structural point of view, the path-type indices [102, 103, 106-109,111-113] can be divided into two subgroups ... 

Point Combustible Gas Detectors (IR) are used to indicate the presence of gas at a particular location (e.g., in a congested area of the planter in small ducts.) IR technology has proven to be more reliable than catalytic bead detectors. The point detector functions in the same manner as the open path detector, by comparing absorbed and reference frequencies of IR light. The main difference between these and open path type is that the path length of the point type is short (3 inches) and is kept within the confines of the instrument. 

Saddle point p is the sink of type III trajectories, i.e. it is the attractor of all trajectories in directions perpendicular to the MED path. Type III trajectories form a surface, which reaches from infinity (source of type III trajectories) to a line L through the center of the ring and perpendicular to the ring plane. The flux of Vp(r) vanishes for all surface points (equation 6) ... 

The three MED paths (type II trajectories)between the C atoms of 1 correspond to the three CC bonds. Since MED paths can also be found in the case of van der Waals interactions, Cremer and Kraka13,68,69 suggested using the local energy density H(r) (equation 7) ... 

Path-Type MCIs A path in a molecular graph is an ordered set of consecutive bonds (bi, b2, bi,..., bm) with the property that bond bk (1 < k < m) starts from the atom where bond bk-1 ends. The length of such a path is m. The order of a path equals its length m. The general formula for a path-type MCI is... 

Time-of-flight ultrasonic flow meter single-path type. 

According to Uhlmann and Ardelt [9,10], greater changes in performance can be achieved by varying the path type than by varying the grinding pressure or path velocity. 

Servo-type robots use servo motors or valves to move the manipulator members and can be further classified into either point-to-point or continuous-path types. Point-to-point servo robots are programmed or taught by feeding them manipulator-position data at discrete points and, in performing a task, they will internally select a path to that point. Continuous-path servo robots are programmed or taught to follow a precise path and are used for operations where movement is important, particularly in spray painting. 

Endpoint f reg (rising edge-triggered flip-flop clocked by elk) Constraint Group elk Path Type max... 

Endpoint UPREAD[24] (output port clocked by SELECT) Path Group SELECT Path Type min... 

To see the startup user s path, type at the prompt command ... 

After saving the M-file in MATLAB s search path, type the name of the M-file without extension. Notice that naming is case sensitive. You must be very aware of this issue or you will experience problems with MATLAB. 

---