Other Types of Agents

This reaction is run by heating the alcohol in the presence of concentrated sulfuric acid, a good dehydrating agent. Diethyl ether, CH,CH2OCH2CH3, was formerly used as an anesthetic in surgery, but it caused undesirable side effects in many patients, and was replaced by other types of agents. 

This is not attributable simply to boredom, since at very low doses and with other types of agents, daytime sleeping is either absent or limited to short naps... ... 

As with the traditional types of tumour therapy, the success of antibody therapy is always endangered by the potential emergence of resistant clones. To reduce this risk, antibodies are typically used in combination or altematingly with other types of agents. 

Toxicity of organophosphates can be potentiated 15-20-fold in rats and mice by pretreatment with a metabolite of tri-O-cresylphosphate, CBDP (2-0-cresyl)-4H-l,3,2-benzodioxa-phosphorin-2-oxide), which is an irreversible inhibitor of CarbEs. In similar studies, tetraisopropylpyrophosphoramide (iso-OMPA), or mipafox, an organophosphate-irreversible inhibitor of CarbEs, potentiates three-to fivefold the toxicity of several OPs (soman, DFP, and methylparathion) and carbamates (carbofuran, aldicarb, propoxur, and carbaryl). Inhibition of CarbEs by CBDP, iso-OMPA, or mipafox pretreatment, particularly in plasma, liver, heart, brain, and skeletal muscles, is a major contributory factor in the potentiation of toxicity of organophosphates and carbamates. Thus, the toxicity of any drug, pesticide, or other type of agent that is normally detoxified by CarbEs, could be potentiated by pre-exposure to an organophosphorus or other carboxylesterase inhibitor. 

TaMe 8.2 Mechanistic Classification of Antidepressants and Other Types of Agents/Mechanisms Currently Being Explored for the Treatment of Depression... 

Agent Layer the model contains only one type of agent that represents the General population as we have considered, for this example, that all other types of agents are trusted. 

Rubber. The mbber industry consumes finely ground metallic selenium and Selenac (selenium diethyl dithiocarbamate, R. T. Vanderbilt). Both are used with natural mbber and styrene—butadiene mbber (SBR) to increase the rate of vulcanization and improve the aging and mechanical properties of sulfudess and low sulfur stocks. Selenac is also used as an accelerator in butyl mbber and as an activator for other types of accelerators, eg, thiazoles (see Rubber chemicals). Selenium compounds are useflil as antioxidants (qv), uv stabilizers, (qv), bonding agents, carbon black activators, and polymerization additives. Selenac improves the adhesion of polyester fibers to mbber. 

Water Treatment. Sodium sulfite is an agent in the reduction of chlorine or oxygen in water. Dissolved oxygen in boiler water tends to enhance pitting and other types of corrosion. In boilers operated at below 4.82 MPa (700 psi), a residual concentration of 30 ppm of sodium sulfite is generally effective. Catalytic amounts of cobalt are often added to accelerate the reaction of oxygen with sulfite (321,322) (see Water, industrial water treatment). 

Neutralizing removes the large amount of hexavalent chromium from the surface of the part. Hexavalent chromium shortens the life of the catalyst, and trace amounts completely inhibit electroless nickel deposition. The neutralizer is usually a mildly acidic or basic reducing agent, but other types of neutralizers are available, especially for substrates that are difficult to plate. The neutralizer may also contain surfactants (qv) or other compounds that increase catalyst absorption absorption promoters are often needed for non-ABS plastics. 

The first step of the Combes reaction has been reported to occur by merely mixing an aniline and diketone in an alcoholic solvent, or neat, with slight warming. Dilute aqueous acid (2 M HCl), AcOH, ZnCh as well as CaCl2, or other types of drying agents have been used to promote the first step. 

Other factors have been identified as rate controlling in other types of solid—solid interaction, and some of these are described in subsequent sections. These include, for example, the decomposition of a solid catalyzed by a (different) solid and rate processes in which one reactant is volatilized, e.g. reaction of carbon (-> C02) with a solid oxidizing agent. 

Anti-protozoa agents are utilized to treat diseases such as coccidiosis, which affects many farm animals, particularly poultry. Coccidiostats include polyether monocar-boxylic acid ionophores and other types of compounds. Polyether monocarboxylic acid ionophores include monesin, narasin, lasalocid, and salinomycin. The most common of these is salinomycin. Nonionophore coccidiostats include dimetridazole and halofunginone. Stanker et al. reviewed immunoassays available for coccidio-static agents. 

---