Nucleophilic substitution displacement reactions

The apphcation of bimolecular, nucleophilic substitution (S ) reactions to sucrose sulfonates has led to a number of deoxhalogeno derivatives. Selective displacement reactions of tosyl (79,85), mesyl (86), and tripsyl (84,87) derivatives of sucrose with different nucleophiles have been reported. The order of reactivity of the sulfonate groups in sucrose toward reaction has been found to be 6 > 6 > 4 > 1. ... 

Acid chlorides react with diorganocuprate reagents to form ketones (Following fig.). Like the Grignard reaction, an alkyl group displaces the chloride ion to form a ketone. However, unlike the Grignard reaction, the reaction stops at the ketone stage. The mechanism is believed to be radical based rather than nucleophilic substitution. The reaction does not occur with carboxylic acids, acid anhydrides, esters, or amides. 

Rearrangement reactions, including internal nucleophilic substitution/displacement and skeletal rearrangement reactions. 

Nucleophilic Aromatic Displacement Reactions. Nucleophilic Addition and Substitution at Carboxyl Groups. ... 

The high performance characteristics of polyetherimide polymers and our desire to prepare them by an economically attractive scheme led us to explore several synthetic approaches. The key reaction in all of these was the formation of the diaryl ether linkage by a nucleophilic aromatic displacement reaction on suitably substituted (and activated) phthalic derivatives. Chloride displacement proceeded relatively slowly and gave polymers having only modestly high molecular weights. Fluoride displacement was quite facile, but processes based on the fluoro-deriviatives were economically unattractive. The synthetic and economic accessibility of appropriate nitro-substituted phthalic... 

In an acidic medium, the maximum cation coordination is always achieved in the aquo-hydroxo monomeric complex, and hence the reaction must proceed though nucleophilic substitution. This reaction may take place via one of three simple mechanisms dissociation, association and a concerted mechanism or direct displacement [9]. 

Nucleophilic substitution of benzene itself is not possible but the halogeno derivatives undergo nucleophilic displacement or elimination reactions (see arynes). Substituents located in the 1,2 positions are called ortho- 1,3 meta- and 1,4 para-. 

The Pd—C cr-bond can be prepared from simple, unoxidized alkenes and aromatic compounds by the reaction of Pd(II) compounds. The following are typical examples. The first step of the reaction of a simple alkene with Pd(ll) and a nucleophile X or Y to form 19 is called palladation. Depending on the nucleophile, it is called oxypalladation, aminopalladation, carbopalladation, etc. The subsequent elimination of b-hydrogen produces the nucleophilic substitution product 20. The displacement of Pd with another nucleophile (X) affords the nucleophilic addition product 21 (see Chapter 3, Section 2). As an example, the oxypalladation of 4-pentenol with PdXi to afford furan 22 or 23 is shown. 

Pd(II) compounds coordinate to alkenes to form rr-complexes. Roughly, a decrease in the electron density of alkenes by coordination to electrophilic Pd(II) permits attack by various nucleophiles on the coordinated alkenes. In contrast, electrophilic attack is commonly observed with uncomplexed alkenes. The attack of nucleophiles with concomitant formation of a carbon-palladium r-bond 1 is called the palladation of alkenes. This reaction is similar to the mercuration reaction. However, unlike the mercuration products, which are stable and isolable, the product 1 of the palladation is usually unstable and undergoes rapid decomposition. The palladation reaction is followed by two reactions. The elimination of H—Pd—Cl from 1 to form vinyl compounds 2 is one reaction path, resulting in nucleophilic substitution of the olefinic proton. When the displacement of the Pd in 1 with another nucleophile takes place, the nucleophilic addition of alkenes occurs to give 3. Depending on the reactants and conditions, either nucleophilic substitution of alkenes or nucleophilic addition to alkenes takes place. 

An important method for construction of functionalized 3-alkyl substituents involves introduction of a nucleophilic carbon synthon by displacement of an a-substituent. This corresponds to formation of a benzylic bond but the ability of the indole ring to act as an electron donor strongly influences the reaction pattern. Under many conditions displacement takes place by an elimination-addition sequence[l]. Substituents that are normally poor leaving groups, e.g. alkoxy or dialkylamino, exhibit a convenient level of reactivity. Conversely, the 3-(halomethyl)indoles are too reactive to be synthetically useful unless stabilized by a ring EW substituent. 3-(Dimethylaminomethyl)indoles (gramine derivatives) prepared by Mannich reactions or the derived quaternary salts are often the preferred starting material for the nucleophilic substitution reactions. 

The reactions of alcohols with hydrogen halides to give alkyl halides (Chapter 4) are nucleophilic substitution reactions of alkyloxonium ions m which water is the leaving group Primary alcohols react by an 8 2 like displacement of water from the alkyloxonium ion by halide Sec ondary and tertiary alcohols give alkyloxonium ions which form carbo cations m an S l like process Rearrangements are possible with secondary alcohols and substitution takes place with predominant but not complete inversion of configuration... 

The Hell-Volhard-Zehnsky reaction is of synthetic value m that the a halogen can be displaced by nucleophilic substitution... 

Delignification Chemistty. The chemical mechanism of sulfite delignification is not fully understood. However, the chemistry of model compounds has been studied extensively, and attempts have been made to correlate the results with observations on the rates and conditions of delignification (61). The initial reaction is sulfonation of the aUphatic side chain, which occurs almost exclusively at the a-carbon by a nucleophilic substitution. The substitution displaces either a hydroxy or alkoxy group ... 

Nitrogen nucleophiles used to diplace the 3 -acetoxy group include substituted pyridines, quinolines, pyrimidines, triazoles, pyrazoles, azide, and even aniline and methylaniline if the pH is controlled at 7.5. Sulfur nucleophiles include aLkylthiols, thiosulfate, thio and dithio acids, carbamates and carbonates, thioureas, thioamides, and most importandy, from a biological viewpoint, heterocycHc thiols. The yields of the displacement reactions vary widely. Two general approaches for improving 3 -acetoxy displacement have been reported. One approach involves initial, or in situ conversion of the acetoxy moiety to a more facile leaving group. The other approach utilizes Lewis or Brmnsted acid activation (87). 

Methyl bromide slowly hydrolyzes in water, forming methanol and hydrobromic acid. The bromine atom of methyl bromide is an excellent leaving group in nucleophilic substitution reactions and is displaced by a variety of nucleophiles. Thus methyl bromide is useful in a variety of methylation reactions, such as the syntheses of ethers, sulfides, esters, and amines. Tertiary amines are methylated by methyl bromide to form quaternary ammonium bromides, some of which are active as microbicides. 

Broadly speaking, nucleophilic substitution may be divided into (a) the direct displacement of hydrogen and (b) the displacement of other substituents. Displacements of type (a) are rare and are typified by the Tschitschibabin reaction. Pyrazine reacts with NaNHa/NHs to yield 2-aminopyrazine, but no yield has been quoted (46USP2394963). Generally, the synthesis of aminopyrazines, aminoquinoxalines and aminophenazines is more readily accomplished by alternative methods, particularly displacement of halogen from the corresponding halo derivatives, which are themselves readily available. 

---