Nuclear industry, surface analysis

In the past ten years the number of chemistry-related research problems in the nuclear industry has increased dramatically. Many of these are related to surface or interfacial chemistry. Some applications are reviewed in the areas of waste management, activity transport in coolants, fuel fabrication, component development, reactor safety studies, and fuel reprocessing. Three recent studies in surface analysis are discussed in further detail in this paper. The first concerns the initial corrosion mechanisms of borosilicate glass used in high level waste encapsulation. The second deals with the effects of residual chloride contamination on nuclear reactor contaminants. Finally, some surface studies of the high temperature oxidation of Alloys 600 and 800 are outlined such characterizations are part of the effort to develop more protective surface films for nuclear reactor applications. ... 

Some Applications of Surface Analysis in the Nuclear Industry... 

Because of the applied nature of much of the work in the nuclear power industry, there are many good examples of surface analysis which will unfortunately, never appear in the open literature. 

Another contribution to variations of intrinsic activity is the different number of defects and amount of disorder in the metallic Cu phase. This disorder can manifest itself in the form of lattice strain detectable, for example, by line profile analysis of X-ray diffraction (XRD) peaks [73], 63Cu nuclear magnetic resonance lines [74], or as an increased disorder parameter (Debye-Waller factor) derived from extended X-ray absorption fine structure spectroscopy [75], Strained copper has been shown theoretically [76] and experimentally [77] to have different adsorptive properties compared to unstrained surfaces. Strain (i.e. local variation in the lattice parameter) is known to shift the center of the d-band and alter the interactions of metal surface and absorbate [78]. The origin of strain and defects in Cu/ZnO is probably related to the crystallization of kinetically trapped nonideal Cu in close interfacial contact to the oxide during catalyst activation at mild conditions. A correlation of the concentration of planar defects in the Cu particles with the catalytic activity in methanol synthesis was observed in a series of industrial Cu/Zn0/Al203 catalysts by Kasatkin et al. [57]. Planar defects like stacking faults and twin boundaries can also be observed by HRTEM and are marked with arrows in Figure 5.3.8C [58],... 

---