Subject nitrogen

A domestic wastewater with a flow of 20,000 mVd is to be denitrified. After settling in the primary clarifier, its BOD5 was reduced to 150 mg/L. The BOD5 required for nitrification was found to be 4.21 mmol/L. Assuming all kinetic parameters are known, calculate the concentration of nitrate nitrogen subjected to denitrification. 

For trace quantities of less than 100 ppm, the most successful method — and the most costly— is neutron activation. The sample is subjected to neutron bombardment in an accelerator where oxygen 16 is converted to unstable nitrogen 16 having a half-life of seven seconds. This is accompanied by emission of (J and 7 rays which are detected and measured. Oxygen concentrations as low as 10 ppm can be detected. At such levels, the problem is to find an acceptable blank sample. 

The collector contains an electrically-heated rubidium salt used as the thermionic source. During the elution of a molecule of a nitrogen compound, the nitrogen is ionized and the collection of these ions produces the signal. The detector is very sensitive but Its efficiency is variable subject to the type of nitrogen molecule, making quantification somewhat delicate. 

This recrystallised acid is pure in the norm y accepted sense of the word, namely it has a sharp m.p. and gives on analysis excellent values for carbon, hydrogen and nitrogen. If however it is subjected to one-dimensional paper chromatography (p. 53), the presence of traces of unchanged anthranilic acid can be detected, and repeated recrystallisation is necessary to remove these traces. 

The exocychc nitrogens on cytosine and the purine bases must be protected during the synthesis. The search is ongoing for protecting groups that are subject to fewer side reactions and that can be removed more easily in the final deprotection step (34). 

The WAG process has been used extensively in the field, particularly in supercritical CO2 injection, with considerable success (22,157,158). However, a method to further reduce the viscosity of injected gas or supercritical fluid is desired. One means of increasing the viscosity of CO2 is through the use of supercritical C02-soluble polymers and other additives (159). The use of surfactants to form low mobihty foams or supercritical CO2 dispersions within the formation has received more attention (160—162). Foam has also been used to reduce mobihty of hydrocarbon gases and nitrogen. The behavior of foam in porous media has been the subject of extensive study (4). X-ray computerized tomographic analysis of core floods indicate that addition of 500 ppm of an alcohol ethoxyglycerylsulfonate increased volumetric sweep efficiency substantially over that obtained in a WAG process (156). 

Measurement and specification of nitrates or other nitrogen oxide compounds in sulfuric acid is a complex subject. The difficulty occurs because nitrogen oxides are usually present both as nitrous and nitric compounds, predominantiy in the nitrous form. Hence, analytical procedures specific for nitrates only do not give a complete analysis. 

---