2- Naphthol hydrogenation

Isopropylnaphthalenes can be prepared readily by the catalytic alkylation of naphthalene with propjiene. 2-lsopropylnaphthalene [2027-17-0] is an important intermediate used in the manufacture of 2-naphthol (see Naphthalenederivatives). The alkylation of naphthalene with propjiene, preferably in an inert solvent at 40—100°C with an aluminum chloride, hydrogen fluoride, or boron trifluoride—phosphoric acid catalyst, gives 90—95% wt % 2-isopropylnaphthalene however, a considerable amount of polyalkylate also is produced. Preferably, the propylation of naphthalene is carried out in the vapor phase in a continuous manner, over a phosphoric acid on kieselguhr catalyst under pressure at ca 220—250°C. The alkylate, which is low in di- and polyisopropylnaphthalenes, then is isomerized by recycling over the same catalyst at 240°C or by using aluminum chloride catalyst at 80°C. After distillation, a product containing >90 wt % 2-isopropylnaphthalene is obtained (47). 

Naphthaleneamine. 1-Naphthylamine or a-naphth5iamine/7i5 -i2- can be made from 1-nitronaphthalene by reduction with iron—dilute HCl, or by catalytic hydrogenation it is purified by distillation and the content of 2-naphthylamine can be reduced as low as 8—10 ppm. Electroreduction of 1-nitronaphthalene to 1-naphthylamine using titania—titanium composite electrode has been described (43). Photoinduced reduction of 1-nitronaphthalene on semiconductor (eg, anatase) particles produces 1-naphthylamine in 77% yield (44). 1-Naphthylamine/7J4-J2-. can also be prepared by treating 1-naphthol with NH in the presence of a catalyst at elevated temperature. The sanitary working conditions are improved by gas-phase reaction at... 

Acid-cataly2ed hydroxylation of naphthalene with 90% hydrogen peroxide gives either 1-naphthol or 2-naphthiol at a 98% yield, depending on the acidity of the system and the solvent used. In anhydrous hydrogen fluoride or 70% HF—30% pyridine solution at — 10 to + 20°C, 1-naphthol is the product formed in > 98% selectivity. In contrast, 2-naphthol is obtained in hydroxylation in super acid (HF—BF, HF—SbF, HF—TaF, FSO H—SbF ) solution at — 60 to — 78°C in > 98% selectivity (57). Of the three commercial methods of manufacture, the pressure hydrolysis of 1-naphthaleneamine with aqueous sulfuric acid at 180°C has been abandoned, at least in the United States. The caustic fusion of sodium 1-naphthalenesulfonate with 50 wt % aqueous sodium hydroxide at ca 290°C followed by the neutralization gives 1-naphthalenol in a ca 90% yield. 

The azo coupling reaction proceeds by the electrophilic aromatic substitution mechanism. In the case of 4-chlorobenzenediazonium compound with l-naphthol-4-sulfonic acid [84-87-7] the reaction is not base-catalyzed, but that with l-naphthol-3-sulfonic acid and 2-naphthol-8-sulfonic acid [92-40-0] is moderately and strongly base-catalyzed, respectively. The different rates of reaction agree with kinetic studies of hydrogen isotope effects in coupling components. The magnitude of the isotope effect increases with increased steric hindrance at the coupler reaction site. The addition of bases, even if pH is not changed, can affect the reaction rate. In polar aprotic media, reaction rate is different with alkyl-ammonium ions. Cationic, anionic, and nonionic surfactants can also influence the reaction rate (27). 

Methyl Amine + a-Naphthol Chloroformate = Carbaryl -I- Hydrogen Chloride,... 

As previously described, a mixture of and J -octalins can be prepared by the reduction of naphthalene or Tetralin. Another route to this mixture is the dehydration of a mixture of 2-decalol isomers. This latter route has certain advantages in that one can avoid the handling of lithium metal and low-boiling amines. Moreover, 2-decalol is available commercially or can be prepared by the hydrogenation of 2-naphthol (5). In either case a comparable mixture of octalins is obtained, which can be purified by selective hydroboration to give the pure J -octalin (Chapter 4, Section III). 

Hydrogenation of 2-naphthol can proceed at either ring with the general tendency to reduce the unsubstituted ring preferentially. The ratio R of... 

Solochrome dark blue or calcon ( C.1.15705). This is sometimes referred to as eriochrome blue black RC it is in fact sodium l-(2-hydroxy-l-naphthylazo)-2-naphthol-4-sulphonate. The dyestuff has two ionisable phenolic hydrogen atoms the protons ionise stepwise with pK values of 7.4 and 13.5 respectively. An important application of the indicator is in the complexometric titration of calcium in the presence of magnesium this must be carried out at a pH of about 12.3 (obtained, for example, with a diethylamine buffer 5 mL for every 100 mL of solution) in order to avoid the interference of magnesium. Under these conditions magnesium is precipitated quantitatively as the hydroxide. The colour change is from pink to pure blue. 

Formation of hydrogen bonds between phenols and naphthols on the one hand, and dimethyl, divinyl, diphenyl sulphoxides and other sulphinyl or sulphonyl derivatives on the other, have also been documented in the literature95-97. 

I, 4-benzoquinone.4 Other methods that have been employed include the oxidation of naphthalene with hydrogen peroxide,5 the oxidation of 1,4-naphthalenediamine 6 and naphthylamine sulfonic acid 7 and the oxidation of 4-amino-1-naphthol prepared by electrolytic reduction of 1-nitronaphthalene.8... 

Naphthoquinone was completely eliminated and hydrogenated to naphthol and dihydroxynaphthalene as reported by Brower (15). 

In another procedure [522] the sample of seawater (0.5-3 litres) is filtered through a membrane-filter (pore size 0.7 xm) which is then wet-ashed. The nickel is separated from the resulting solution by extraction as the dimethylglyoxime complex and is then determined by its catalysis of the reaction of Tiron and diphenylcarbazone with hydrogen peroxide, with spectrophotometric measurement at 413 nm. Cobalt is first separated as the 2-nitroso-1-naphthol complex, and is determined by its catalysis of the oxidation of alizarin by hydrogen peroxide at pH 12.4. Sensitivities are 0.8 xg/l (nickel) and 0.04 xg/l (cobalt). 

Two different approaches have been used to determine phenols without derivatization. In the first, the corresponding oxalate esters were synthesized in the traditional way (i.e., using oxalyl chloride and triethylamine) [111, 112]. Pen-tachlorophenol, 1-naphthol, bromofenoxim, bromoxynil, and /t-cyanophenol were treated this way, after which the POCL resulting from their reaction was measured in a static system. The second approach exploits the oxidation reaction between imidazole and hydroxyl compounds at an alkaline pH, where hydrogen peroxide is formed [113]. Polyphenols, e.g., pyrogallol, pyrocatechol, and dopa-... 

As the reaction temperature increases, the equilibrium constant diminishes, since complex formation is accompanied by heat liberation. Sterically hindered phenols form loose complexes because of the impeding effect of voluminous alkyl substituents in the ortho-position. Hydrogen bonding reduces the activity of phenols, which was first observed in the studies of the effects of cyclohexanol and butanol on the inhibitory activity of a-naphthol in cyclohexane [9]. This phenomenon was investigated in detail with reference to the oxidation of methylethylketone [10]. The k7 values for some inhibitors of the oxidation of ethylbenzene and methylethylketone are given below (333 K) [10,46] ... 

---