Charged monolayers

Work of a similar nature, involving hydrous oxide growth on platinum under square-wave perturbation conditions in acid, has been reported recently by Chialvo et al.137 Changes in real surface area were monitored by measuring the hydrogen monolayer charge before and after the hydrous oxide growth and reduction processes. The optimum limits observed in this case (especially the lower value... 

In this chapter, we have reviewed the role of the two interfaces in the operation of the organic transistor. The interface between the semiconductor and the insulator is crucial because it is the very place where the conducting channel emerges. Because its thickness does not exceed a few monolayers, charge transport in the conducting channel is mainly dictated by the quality of this interface. Under that respect, the... 

Stem layer adsorption was involved in the discussion of the effect of ions on f potentials (Section V-6), electrocapillary behavior (Section V-7), and electrode potentials (Section V-8) and enters into the effect of electrolytes on charged monolayers (Section XV-6). More speciflcally, this type of behavior occurs in the adsorption of electrolytes by ionic crystals. A large amount of wotk of this type has been done, partly because of the importance of such effects on the purity of precipitates of analytical interest and partly because of the role of such adsorption in coagulation and other colloid chemical processes. Early studies include those by Weiser [157], by Paneth, Hahn, and Fajans [158], and by Kolthoff and co-workers [159], A recent calorimetric study of proton adsorption by Lyklema and co-workers [160] supports a new thermodynamic analysis of double-layer formation. A recent example of this is found in a study... 

If an ionic surfactant is present, the potentials should vary as shown in Fig. XIV-5c, or similarly to the case with nonsurfactant electrolytes. In addition, however, surfactant adsorption decreases the interfacial tension and thus contributes to the stability of the emulsion. As discussed in connection with charged monolayers (see Section XV-6), the mutual repulsion of the charged polar groups tends to make such films expanded and hence of relatively low rr value. Added electrolyte reduces such repulsion by increasing the counterion concentration the film becomes more condensed and its film pressure increases. It thus is possible to explain qualitatively the role of added electrolyte in reducing the interfacial tension and thereby stabilizing emulsions. 

Films spread at liquid-liquid interfaces or on liquids other than water are discussed followed by the important effects of charged monolayers on water. Finally, the most technologically important application of Langmuir films, the Langmuir-Blodgett film deposited on a solid substrate, is reviewed. 

Fig. XV-12. Electrical lines of force for a charged monolayer. (From Ref. 114)...

Because of the charged nature of many Langmuir films, fairly marked effects of changing the pH of the substrate phase are often observed. An obvious case is that of the fatty-acid monolayers these will be ionized on alkaline substrates, and as a result of the repulsion between the charged polar groups, the film reverts to a gaseous or liquid expanded state at a much lower temperature than does the acid form [121]. Also, the surface potential drops since, as illustrated in Fig. XV-13, the presence of nearby counterions introduces a dipole opposite in orientation to that previously present. A similar situation is found with long-chain amines on acid substrates [122]. 

Zhao X L, Ong S W and Eisenthal K B 1993 Polarization of water-molecules at a charged interface. Second harmonic studies of charged monolayers at the air/water interface Chem. Phys. Lett. 202 513-20... 

T = temperature of outgassing of the nonane-charged sample, n. = monolayer capacity calculated from the BET plot. 

Trace contaminants are also significant at charged solid surfaces, affecting both the charging process and the surface conductivity. In ambient air atmospheres their effect is often determined by interaction with adsorbed water vapor, whose dominant concentration may be sufficiently large to form a monolayer. Topical antistatic agents for solids typically rely on interaction with adsorbed water and can lose effectiveness at low relative humidity (4-2.1). 

Elemental sensitivity Scales as the square of nuclear charge best for heavy elements (< 10 monolayer) poor for hydrogen... 

In some cases, e.g., the Hg/NaF q interface, Q is charge dependent but concentration independent. Then it is said that there is no specific ionic adsorption. In order to interpret the charge dependence of Q a standard explanation consists in assuming that Q is related to the existence of a solvent monolayer in contact with the wall [16]. From a theoretical point of view this monolayer is postulated as a subsystem coupled with the metal and the solution via electrostatic and non-electrostatic interactions. The specific shape of Q versus a results from the competition between these interactions and the interactions between solvent molecules in the mono-layer. This description of the electrical double layer has been revisited by... 

The integrated charge would correspond to 0.7 0.1 Cu monolayers. Thus, either a less closely packed Cu layer or an anion co-adsorption that can both lead to a Moire superstructure are probed in the solution investigated [Al2Cl7] is the predominant anion. At h-200 mV vs. Cu/CW the superstructure disappears and a completely closed Cu monolayer is observed, with a charge corresponding to 1.0 0.1 Cu monolayers. 

---