Molybdenum spectrum

Fig. 1-15. The molybdenum spectrum excited by 35-kv electrons and by the polychromatic beam from a 35-kv x-ray tube. With x-ray excitation, most of the energy appears in the characteristic lines. With electron excitation, most of it is wasted in the continuous spectrum.

The curve to which Dr. Allison refers represents very well the main features of the molybdenum spectrum reflected by KBr and observed by its ionizing effected in a chamber containing methyl iodide. On the curve can be seen (a) the short wave-length limit of the continuous spectrum, (5) the abrupt decrease in the ionization current at the critical ionization wave-length of the iodine in the chamber, (c) the K-series lines of molybdenum, reflected in four orders (and even the y-line in the fifth) and, (d)... 

Gr. technetos, artificial) Element 43 was predicted on the basis of the periodic table, and was erroneously reported as having been discovered in 1925, at which time it was named masurium. The element was actually discovered by Perrier and Segre in Italy in 1937. It was found in a sample of molybdenum, which was bombarded by deuterons in the Berkeley cyclotron, and which E. Eawrence sent to these investigators. Technetium was the first element to be produced artificially. Since its discovery, searches for the element in terrestrial material have been made. Finally in 1962, technetium-99 was isolated and identified in African pitchblende (a uranium rich ore) in extremely minute quantities as a spontaneous fission product of uranium-238 by B.T. Kenna and P.K. Kuroda. If it does exist, the concentration must be very small. Technetium has been found in the spectrum of S-, M-, and N-type stars, and its presence in stellar matter is leading to new theories of the production of heavy elements in the stars. 

Samples were tested on in a melt of salts (75% Na SO, 25% NaCl) at 950°C in an air atmosphere for 24 hours. Micro X-rays spectrum by the analysis found that the chemical composition of carbides of an alloy of the ZMI-3C and test alloys differs noticeably. In the monocarbide of phase composition of an alloy of the ZMI-3C there increased concentration of titanium and tungsten is observed in comparison with test alloys containing chemical composition tantalum. The concentration of more than 2% of tantalum in test alloys has allowed mostly to deduce tungsten from a mono carbide phase (MC) into solid solution. Thus resistance of test alloys LCD has been increased essentially, as carbide phase is mostly sensitive aggressive environments influence. The critical value of total molybdenum and tungsten concentration in MC should not exceed 15%. 

Figure 2 Molybdenum K-edge X-ray absorption spectrum, ln(i /i ) versus X-ray energy (eV), for molybdenum metal foil (25- jjn thick), obtained by transmission at 77 K with synchrotron radiation. The energy-dependent constructive and destructive interference of outgoing and backscattered photoelectrons at molybdenum produces the EXAFS peaks and valleys, respectively. The preedge and edge structures marked here are known together as X-ray absorption near edge structure, XANES and EXAFS are provided in a new compilation of literature entitled X-rsy Absorption Fine Structure (S.S. Hasain, ed.) Ellis Norwood, New York, 1991.

Some data have been obtained on the activity of the catalyst in a reduced state [for nickel (141,143,144), palladium (144°), and molybdenum (145, 145a). In the case of nickel catalysts the formation of nickel in the zero oxidation state takes place during the reduction of the surface organometallic compound by H2. The infrared spectrum shows the total restoration of the concentration of Si—OH groups (139), so the reduction proceeds according to the scheme ... 

A second unusual EPR spectrum was observed in the oxidized (as-isolated) protein (Fig. 3). This spectrum, which was assigned to an S = z system, was not reminiscent of any Fe-S cluster. Indeed, with g-values of 1.968, 1.953, and 1.903, it looked more like a molybdenum or tungsten spectrum. However, chemical analysis ruled out the possibility that this EPR spectrum arose from Mo or W, and the spectrum was assigned to an Fe-S center instead. The spin concentration, however, was sub stoichiometric and sample-dependent. Furthermore, when the as-isolated protein was oxidized with ferricyanide, it became EPR silent. This, together with the iron determination and the fingerprint of the reduced protein, led Hagen and colleagues to the... 

UV-visible spectra of the cluster 1 and molybdenum/zeolite catalysts are shown in Figure 1. The cluster 1 showed bands at 300, 390 and ca. 650 nm. Similar bands were observed for the spectrum of each molybdenum/zeolite catalyst, suggesting that the structure of cluster 1 was practically unchanged after ion exchange. 

Figure 2.1. The X-ray spectrum of molybdenum, showing Ka and Kp lines superimposed upon the continuous spectrum. The quantum energy is shown in the upper scale the intensity is in arbitrary units.

Of experimental methods for studying the metal in enzymes, light absorption in the visible region from molybdenum chromophores is likely to be weak and frequently masked by stronger absorption from other enzyme constituents. Indeed only recently has a small molybdenum contribution to the absorption spectrum of even the most studied of these enzymes, xanthine oxidase, been demonstrated 33, see Section V F). 

Cover Illustration Atomic force microscopy image of molybdenum oxide particles on flat, silicon dioxide substrate, which serves as a model system for a supported catalyst. The area shown corresponds to one square micrometer the maximum difference in height is approximately 10 nanometer. The superimposed curve is the secondary ion mass spectrum of the model catalyst, showing the caracteristic isotopic patterns of single molybdenum ions and of molybdenum oxide cluster ions. 

Fig. 1 illustrates the types of reaction pathway which have been proposed to be of importance in the decomposition reaction. In practice, where additional processes such as reforming of DME may possibly occur, the reaction scheme could be much more complex than that shown. For example, on the basis of the product spectrum over molybdenum oxycarbide dimers reported in NaY,20 the following pathway has... 

Superoxide ions, 02, are readily formed by the transfer of electrons from Fs centers on MgO or from Mo(V) on Mo/Si02 to molecular oxygen (7, 9). The value of g3 for 02 is particularly sensitive to the crystal field gradient at the surface and thus varies from one metal oxide to another (10). In fact, the spectrum of 01 on MgO indicates that the ions are held at four distinctly different sites (11,12). The oxygen-17 hyperfine splitting (Table I) for 170170- on MgO confirms that both oxygen atoms are equivalent, on supported molybdenum the atoms are nonequivalent, suggesting a peroxy-type bond to the metal (7,13). 

Of course, not all dissolved ions produce colored solutions, and therefore not all ions in solution can be quantified by colorimetry. Noncolored solutions can sometimes, however, be converted to colored solutions by introducing chromophore species which complex with (i.e., attach themselves to) the target ion to produce a colored solution, which may then be measured by UV/visible colorimetry. An important archaeological example of this is the determination of phosphorus in solution (which is colorless) by com-plexation with a molybdenum compound, which gives a blue solution (see below). The term colorimetry applies strictly only to analytical techniques which use the visible region of the spectrum, whereas spectrophotometry may be applied over a wider range of the electromagnetic spectrum. 

---