Mixing equipment cooling

Even if the reactor temperature is controlled within acceptable limits, the reactor effluent may need to be cooled rapidly, or quenched, to stop the reaction quickly to prevent excessive byproduct formation. This quench can be accomplished by indirect heat transfer using conventional heat transfer equipment or by direct heat transfer by mixing with another fluid. A commonly encountered situation is... 

In a 2-litre round-bottomed flask, equipped with a double surface condenser, place 60 g. of triniethylene dicyanide (Section 111,114) and 900 g. of 50 per cent, sulphuric acid (by weight). Reflux the mixture for 10 hours and allow to cool. Saturate the solution with ammonium sul phate and extract wit-h four 150 ml. portions of ether dry the ethereal extracts with anhydrous sodium or magnesium sulphate. Distil off the ether on a water bath the residual glutaric acid (69 g.) crystallises on cooling and has m.p. 97-97-5°. Upon recrystalhsation from chloroform, or benzene, or benzene mixed with 10 per cent, by weight of ether, the m.p. is 97 -5-98°. 

Method 1 (with acetyl chloride). Equip a dry 500 ml. round-bottomed or bolt-head flask with a reflux condenser, and fit the top of the condenser with a two hole cork, one opening for a separatory funnel and the other for a delivery tube connected to an inverted funnel which dips just below the surface of about 200 ml. of water in a beaker (compare Fig. II, 13, 8). Place 40 g. of anhydrous, finely-powdered aluminium chloride (see Section IV,2) and 88 g. (100 ml.) of dry A.R. benzene in the flask and cool the latter in a bath of cold water (not ice water since benzene may crystallise). Through the separatory funnel at the top of the condenser add 29 g. (27 ml.) of redistilled acetyl chloride slowly during half an hour and shake the flask frequently to ensure thorough mixing of the... 

The hydrolysis by alkali is illustrated by the following experimental details for benzamido. Place 3 g. of benzamide and 50 ml. of 10 per cent, sodium hydroxide solution in a 150 ml. conical or round-bottomed flask equipped with a reflux condenser. Boil the mixture gently for 30 minutes ammonia is freely evolved. Detach the condenser and continue the boiling in the open flask for 3-4 minutes to expel the residual ammonia. Cool the solution in ice, and add concentrated hydrochloric acid until the mixture is strongly acidic benzoic acid separates immediately. Leave the mixture in ice until cold, filter at the pump, wash with a little cold water and drain well. RecrystaUise the benzoic acid from hot water. Determine the m.p., and confirm its identity by a mixed m.p. test. 

Ethyl phenylethylmalonate. In a dry 500 ml. round-bottomed flask, fitted with a reflux condenser and guard tube, prepare a solution of sodium ethoxide from 7 0 g. of clean sodium and 150 ml. of super dry ethyl alcohol in the usual manner add 1 5 ml. of pure ethyl acetate (dried over anhydrous calcium sulphate) to the solution at 60° and maintain this temperature for 30 minutes. Meanwhile equip a 1 litre threenecked flask with a dropping funnel, a mercury-sealed mechanical stirrer and a double surface reflux condenser the apparatus must be perfectly dry and guard tubes should be inserted in the funnel and condenser respectively. Place a mixture of 74 g. of ethyl phenylmalonate and 60 g. of ethyl iodide in the flask. Heat the apparatus in a bath at 80° and add the sodium ethoxide solution, with stirring, at such a rate that a drop of the reaction mixture when mixed with a drop of phenolphthalein indieator is never more than faintly pink. The addition occupies 2-2 -5 hoius continue the stirring for a fiuther 1 hour at 80°. Allow the flask to cool, equip it for distillation under reduced pressure (water pump) and distil off the alcohol. Add 100 ml. of water to the residue in the flask and extract the ester with three 100 ml. portions of benzene. Dry the combined extracts with anhydrous magnesium sulphate, distil off the benzene at atmospheric pressure and the residue under diminished pressure. C ollect the ethyl phenylethylmalonate at 159-160°/8 mm. The yield is 72 g. 

---