Mixing Considerations

As mentioned earlier, mixing requirements for crystallizers involve all aspects of transport properties momenrnm, energy, and mass. 

For momentum transport, i.e., velocity profile and impact on crystallization, they include 

Longer periods of shear resulted in extended dissolution times. The authors also noted that powder blend bulk and tapped densities increased as lubricant blend times increased. The increased density was attributed to the improved flow properhes of the blend. Although evidence suggests that the spectral variations apparent beyond 20 min in this study are related to the effects of magnesium stearate, further studies are necessary before this can be established with greater certainty. 

---

Mixing Considerations in Multicomponent Miscible Reactive Polymer Processing Systems, 623... 

MIXING CONSIDERATIONS IN MULTICOMPONENT MISCIBLE REACTIVE POLYMER... 

As the potential curves suggest, the A 2I1 and B 2S+ can mix considerably above about B 2S+(u = 5), and since the B 2S+ state has a shorter radiative lifetime, the 2 +-Y 2+ system predominates in the tail bands. The relative intensities of the perturbed lines at low pressure indicated that A 2I1 (t> = 10) was populated in CH2C12 flames about 30 times more rapidly than B 2S+(u = 0), and that A 11 (u = 7) was formed 4 times faster than X2X+ v = 11). 

So, the various mixing considerations put conflicting requirements on the parameters involved in scale-up and there is no clear choice of scale-up rule. Geisler et al. (1993) argue that there is no constant scale-up rule possible... scale-up prediction always... 

In this limit the vibronie states of each site are coupled as if each vibronie state were independent of the others in the same electronic band. In a system consisting of only totally symmetric vibrations it is apparent that all the vibronie bands will have the same symmetry. These states could therefore mix considerably if the splitting became comparable with the vibrational intervals. Thus, in the weak coupling scheme we assume, following Simpson and Peterson (10), that the interactions between... 

Table 4 shows the crack propagation parameters of three concrete mixes in the wind condition in the end of test at 24 hours. Compared with the control mix, the FA binary mix reduced 66.6% in the crack numbers of unit area, and decreased 77.5% in the average crack area, and the level of crack resistance is increased to II grade. However, the inclusion of GGBS in the FA binary mixes considerably reduced the crack resistance. Hence, there is a increased risk of plastic cracking of HPCs with addition of GGBS. 

C (WsC) and tc (CCR) levels mix considerably is indicated by the fact that the transitions of the metallabutadiynes are significantly red shifted from those of nonconjugated methylidyne complexes, such as W(CH)(dmpe)2(w-Bu), and are quite sensitive to the nature of the alkynyl R group (Figure 1).3 Since interactions between 7C (W=C) and tc(CCR) would tend to counteract the shift due to those between tc (W=C) and 7C (CCR), this latter mixing may be greater than that indicated spectroscopically. 

Distributive mixing is related to the total amount of shear, and as a consequence, the most economical regions for distributive mixing are the areas of low viscosity. Rearrangement of the material often increases the distributive mixing considerably. 

Without mechanical mixing considerable coking resulted. 

---