Microwave solid supports

Keywords 2(lH)-Pyrazinone Diels-Alder reaction Microwave Solid support ... 

The Pictet-Spengler reaction has been carried out on various solid support materials " and with microwave irradiation activation.Diverse structural analogues of (-)-Saframycin A have been prepared by carrying out the Pictet-Spengler isoquinoline synthesis on substrates attached to a polystyrene support. Amine 20 was condensed with aldehyde 21 followed by cyclization to give predominantly the cis isomer tetrahydroisoquinoline 22 which was further elaborated to (-)-Saframycin A analogues. 

Microwave irradiation has been used to accelerate the Gewald reaction for the one-pot synthesis of N-acyl aminothiophenes on solid support [67]. A suspension of cyanoacetic acid Wang resin 35, elemental sulfur, DBU and an aldehyde or ketone 36 in toluene was irradiated for 20 min at 120 °C in a single-mode microwave synthesizer (Scheme 13). Acyl chloride 37 was added, followed by DIPEA, and the mixture was irradiated for 10 min at 100 °C. After cooling to room temperature, the washed resin was treated with a TEA solution to give M-acylated thiophenes 38 in 81-99% yield and purities ranging from 46-99%. 

The microwave-assisted solid-supported synthesis of 1,3,4-thiadiazoles was described applying from acid and thiosemicarbazide on acidic aliunina... 

The description of the association of heterocychc chemistry and microwave irradiation has also shown that performing microwave-assisted reactions should be considered with special attention. A few of these considerations can be applied generally for conducting microwave-assisted reactions and include the following (a) the ratio between the quantity of the material and the support (e.g., graphite) or the solvent is very important (b) for solid starting materials, the use of solid supports can offer operational, economical and environmental benefits over conventional methods. However, association of liquid/solid reactants on solid supports may lead to uncontrolled reactions which may result in worse results than the comparative conventional thermal reactions. In these cases, simple fusion of the products or addition of an appropriate solvent may lead to more convenient mixtures or solutions for microwave-assisted reactions. 

Keywords Microwave Heterocyclic Solid-phase Solid-support Soluble-support... 

Cellulose was the first type of solid support introduced for SPPS [91 ] however, the scope of its use is limited by low loading capacity ( 0.1 mmol/g) and chemical stability. In spite of these drawbacks, microwave-assisted synthesis was successfully performed on cellulose membranes [92-94] and beads [95]. 

Since 1986, when the very first reports on the use of microwave heating to chemical transformations appeared [147,148], microwave-assisted synthesis has been shown to accelerate most solution-phase chemical reactions [24-27,32,35]. The first application of microwave irradiation for the acceleration of reaction rate of a substrate attached to a solid support (SPPS) was performed in 1992 [36]. Despite the promising results, microwave-assisted soHd-phase synthesis was not pursued following its initial appearance, most probably as a result of the lack of suitable instriunentation. Reproducing reaction conditions was nearly impossible because of the differences between domestic microwave ovens and the difficulties associated with temperature measurement. The technique became a Sleeping Beauty interest awoke almost a decade later with the publication of several microwave-assisted SPOS protocols [37,38,73,139,144]. There has been an extensive... 

In 2003, the microwave-assisted coupUng of aryl hahdes with acetylenes using a palladium catalyst were carried out employing a modified Smith Process vial [49]. These vessels, equipped with a polypropylene frit and screw cap at the bottom, and sealed with an aluminum crimp cap fitted with a silicon septum at the top (Fig. 8), faciUtated the processing of approximately 1 g of solid support. Notably, they are compatible with stirring of the reaction mixture and monitoring of the temperature and pressure. 

As for the solid support, several polymer-supported amines were tested (Fig. 2). For either the pyrazole and isoxazole synthesis, the best results were given by aniline-functionalized cellulose, which has also the advantage of a relatively low cost. For the 2-aminopyrimidine library, polystyrene-based piperazine and piperidine gave products with a much higher purity compared with other secondary non-cyclic or primary amines, hi both cases, the resins could be reused for up to four times before degradation in their behavior was observed. This reusability could be further enhanced (up to 10 cycles for cellulose-based aniline) when the microwave-assisted protocols were used. 

The synthesis of imidazoles is another reaction where the assistance of microwaves has been intensely investigated. Apart from the first synthesis described since 1995 [40-42], recently a combinatorial synthesis of 2,4,5-trisubstituted and 1,2,4,5-tetrasubstituted imidazoles has been described on inorganic solid support imder solvent-free conditions [43]. Different aldehydes and 1,2 dicarbonyl compounds 42 (mainly benzil and analogues) were reacted in the presence of ammonium acetate to give the trisubstituted ring 43. When a primary amine was added to the mixture, the tetrasubstituted imidazoles were obtained (Scheme 13). The reaction was done by adsorption of the reagent on a solid support, such as silica gel, alumina, montmorillonite KIO, bentonite or alumina followed by microwave irradiation for 20 min in an open vial (multimode reactor). The authors observed that when a non-acid support was used, addition of acetic acid was necessary to obtain good yields of the products. 

Benzofurans have been prepared by microwave-accelerated cyclocondensation of differently substituted salicylaldehydes 182 with esters of chloroacetic acid 183 in the presence of K2CO3 (used as the solid support) and tetrabutyl-ammonium bromide (TBAB) as phase transfer catalyst [120]. This method seemed general regarding the variations at the benzene ring and the nature of the ester moiety (Scheme 66). 

A very detailed comparison for every single step of the whole sequence (linking of a pyrazinone to the solid support, Diels-Alder reaction with acetylenic dienophile and cleavage of a formed pyridinone from the resin) was made between microwave irradiation and conventional heating conditions [115]. 

To perform the cycloaddition on solid-phase, N-l-unprotected pyrazi-nones were coupled with the solid support by treatment of the brominated linker in DMF for 6h at ambient temperature, using CS2CO3 as a base (Scheme 43). The reaction time for complete loading could be dramatically shortened to only 5 min under microwave irradiation at a pre-selected maximum temperature of 70 °C. 

Khan KM et al. (2005) A facile and improved synthesis of sildenafil (Viagra) analogs through solid support microwave irradiation possessing tyrosinase inhibitory potential, their conformational analysis and molecular dynamics simulation studies. Mol Divers 9(l-3) 15-26... 

G. Pourceau, A. Meyer, J.-J. Vasseur, and F. Morvan, Combinatorial and automated synthesis of phosphodiester galactosyl cluster on solid support by click chemistry assisted by microwaves, J. Org. Chem., 73 (2008) 6014—6017. 

Most of the parallel reactions described in Schemes 4.23 and 4.24 were performed as dry-media reactions, in the absence of any solvent. In many cases, the starting materials and/or reagents were supported on an inorganic solid support, such as silica gel, alumina, or clay, that absorbs microwave energy or acts as a catalyst for the reaction (see also Section 4.1). In this context, an interesting method for the optimization of silica-supported reactions has been described [83], The reagents were co-spotted neat or in solution onto a thin-layer chromatographic (TLC) plate. 

In another application, the group of Berteina-Raboin demonstrated the solid-supported synthesis of the indole core of melatonin analogues under microwave irradiation (Scheme 7.6) [26]. A benzoic acid derivative was coupled to Rink amide resin by... 

---