Matrix element, meaning

The completeness of the set of the four eohereney matrix elements means that any plane wave eharaeteristie direetly observable with a traditional optieal instrument is a real-valued linear eombination of these quantities. 

Next, we shall consider four kinds of integrals. The first is the expectation value of the Coulomb potential by one nucleus for one of the primitive basis function centered at that nucleus. The second is the expectation value of the Coulomb potential by one nucleus for one of the primitive basis function centered at a different point (usually another nucleus). Then, we will consider the matrix element of a Coulomb term between two primitive basis functions at different centers. The third case is when one basis function is centered at the nucleus considered. The fourth case is when both basis functions are not centered at that nucleus. By that we mean, for two Gaussian basis functions defined in Eqs. (73) and (74), we are calculating... 

Since the form of the electronic wave functions depends also on the coordinate p (in the usual, parametric way), the matrix elements (21) are functions of it too. Thus it looks at first sight as if a lot of cumbersome computations of derivatives of the electronic wave functions have to be carried out. In this case, however, nature was merciful the matrix elements in (21) enter the Hamiltonian matrix weighted with the rotational constant A, which tends to infinity when the molecule reaches linear geometry. This means that only the form of the wave functions, that is, of the matrix elements in (21), in the p 0 limit are really needed. In the above mentioned one-elecbon approximation... 

A convenience of electronic basis functions (53) is that they reduce at infinitesimal-amplitude bending to (28) with the same meaning of the angle 9 we may employ these asymptotic forms in the computation of the matrix elements of the kinetic energy operator and in this way avoid the necessity of carrying out calculations of the derivatives of the electronic wave functions with respect to the nuclear coordinates. The electronic part of the Hamiltonian is represented in the basis (53) by... 

Thus, the neglect of the off-diagonal matrix elements allows the change from mixed states of the nuclear subsystem to pure ones. The motion of the nuclei leads only to the deformation of the electronic distribution and not to transitions between different electronic states. In other words, a stationary distribution of electrons is obtained for each instantaneous position of the nuclei, that is, the elechons follow the motion of the nuclei adiabatically. The distribution of the nuclei is described by the wave function x (R i) in the potential V + Cn , known as the proper adiabatic approximation [41]. The off-diagonal operators C n in the matrix C, which lead to transitions between the states v / and t / are called operators of nonadiabaticity and the potential V = (R) due to the mean field of all the electrons of the system is called the adiabatic potential. 

Here, Ri f and Rf i are the rates (per moleeule) of transitions for the i ==> f and f ==> i transitions respeetively. As noted above, these rates are proportional to the intensity of the light souree (i.e., the photon intensity) at the resonant frequeney and to the square of a matrix element eonneeting the respeetive states. This matrix element square is oti fp in the former ease and otf ip in the latter. Beeause the perturbation operator whose matrix elements are ai f and af i is Hermitian (this is true through all orders of perturbation theory and for all terms in the long-wavelength expansion), these two quantities are eomplex eonjugates of one another, and, henee ai fp = af ip, from whieh it follows that Ri f = Rf i. This means that the state-to-state absorption and stimulated emission rate eoeffieients (i.e., the rate per moleeule undergoing the transition) are identieal. This result is referred to as the prineiple of microscopic reversibility. 

So far we took the tunneling matrix element /Io to be independent of the vibration coordinates. In terms of our original model with extended tunneling coordinate Q this assumption means that... 

The Huckel methods perform the parameterization on the Fock matrix elements (eqs. (3.50) and (3.51)), and not at the integral level as do NDDO/INDO/CNDO. This means that Huckel methods are non-iterative, they only require a single diagonalization of the Fock (Huckel) matrix. The Extended Huckel Theory (EHT) or Method (EHM), developed primarily by Hoffmann again only considers the valence electrons. It makes use of Koopmans theorem (eq. (3.46)) and assigns the diagonal elements in the F... 

Table X gives an idea of the strength of the various expansion methods, and it shows that, by using the principal term only, one can hardly expect to reach even the above-mentioned chemical margin, even if the wave function W gO(D) is actually very close in the helium case. This means that one has to rely on expansions in complete sets, and the construction of the modern electronic computers has fortunately greatly facilitated the numerical solution of secular equations of high order and the calculation of the matrix elements involved. For atoms, the development will probably go very fast, but, for small molecules one has first to program the conventional Hartree-Fock scheme in a fully self-consistent way for the computers, before the next step can be taken. For large molecules and crystals, the entire situation is much more complicated, and it will hence probably take a rather long time before one can hope to get a detailed understanding of the correlation phenomena in these systems.

The potential surfaces Eg, Hn, and H22 of the HF molecule are described in Fig. 1.6. These potential surfaces provide an instructive example for further considerations of our semiempirical strategy (Ref. 5). That is, we would like to exploit the fact that Hn and H22 represent the energies of electronic configurations that have clear physical meanings (which can be easily described by empirical functions), to obtain an analytical expression for the off-diagonal matrix element H12. To accomplish this task we represent Hn, H22, and Eg by the analytical functions... 

Core matrix elements, H, will be specified with individual methods. Indices k and m refer to closed and open shells, respectively c and y have their usual meaning of expansion coefficients and repulsion integrals, respectively. Numerical values of constants f, a, and b depend on the electronic configuration under study e.g., for a system having an unpaired electron in a nondegenerate... 

Let us describe the solid as having a constant electron density for all energies. Of course, such metals do not exist, but the situation gives us the simplest case. The matrix element Vat has also been assumed to be constant, meaning that A(e) is proportional only to the electron density of the metal. 

In different applications different approximations are introduced during evaluation of the matrix elements Hmn and Smn. Procedures in which the matrix elements are evaluated without further approximation, are called ab initio, which means from the beginning. The quantities e so obtained represent one-electron energies or orbital energies. 

---