Laser photolysis resonance absorption spectroscopy

Table 5 - Overall rate constants and quenching efficiencies for deactivation of O ( Di) as determined at Cornell by laser photolysis-resonance absorption spectroscopy.

The abbreviations used for techniques are DF-RF discharge flow-resonance fluorescence DF-RA discharge flow-resonance absorption DF-ESR discharge flow-esr detection DF-LMR discharge flow with laser magnetic resonance detection of OH DF-MS discharge flow-mass spectrometry FP-KS flash photolysis-kinetic spectroscopy FP-RA flash photolysis-resonance absorption FP-RF flash photolysis-resonance fluorescence MPS modulation-phase shift ... 

A promising recent development in the study of nitrenium ions has been the introduction of time-resolved vibrational spectroscopy for their characterization. These methods are based on pulsed laser photolysis. However, they employ either time resolved IR (TRIR) or time-resolved resonance Raman (TRRR) spectroscopy as the mode of detection. While these detection techniques are inherently less sensitive than UV-vis absorption, they provide more detailed and readily interpretable spectral information. In fact, it is possible to directly calculate these spectra using relatively fast and inexpensive DFT and MP2 methods. Thus, spectra derived from experiment can be used to validate (or falsify) various computational treatments of nitrenium ion stmctures and reactivity. In contrast, UV-vis spectra do not lend themselves to detailed structural analysis and, moreover, calculating these spectra from first principles is still expensive and highly approximate. 

Experimental Techniques A absorption CIMS = chemical ionization mass spectroscopy CK = competitive kinetics DF discharge flow EPR = electron paramagnetic resonance FP = flash photolysis FT = flow tube FTIR Fourier transform intra-red GC = gas chromatography, UF = laser induced fluorescence LMR = laser magnetic resonance MS = mass spectroscopy PLP = pulsed laser photolysis SC = smog chamber SP = steady (continuous) photolysis UVF = ultraviolet flourescence spectroscopy... 

The conditions which determine whether flash photolysis can be used to smdy a given chemical system are (i) a precursor of the species of kinetic interest has to absorb light (normally from a pulsed laser) (ii) this species is produced on a timescale that is short relative to its lifetime in the system. Current technical developments make it easy to study timescales of nanoseconds for production and analysis of species, and the use of instrumentation with time resolution of picoseconds is already fairly common. In certain specific cases, as we will see in the last part of this chapter, it is possible to study processes on timescales greater than a few femtoseconds. Once the species of interest has been produced, it is necessary to use an appropriate rapid detection method. The most common technique involves transient optical absorption spectroscopy. In addition, luminescence has been frequently used to detect transients, and other methods such as time-resolved resonance Raman spectroscopy and electrical conductivity have provided valuable information in certain cases. 

---