Jet-bundle

The pneumatic deposition of the filament bundles onto the moving belt results in formation of the web. A pneumatic gun uses high pressure air to move the filaments through a constricted area of lower pressure but higher velocity, as in a venturi tube. Pneumatic jets used in spunbonded production have been described (17,24). Unfortunately, the exceUent filament uniformity coming out of the spinnerette is lost when the filaments are consoHdated going through a gun. 

Hydraulic jetting with water forced through spray nozzles at high pressure for cleaning tube interiors and exteriors of removal bundles is reported by Canaday ( Hydrauhc Jetting Tools for Cleaning Heat Exchangers, ASME Pap. 5S-A-2I7, unpublished). 

Research effort at Albany International Research Co. has developed unit processes necessary for pilot scale production of several species of reverse osmosis hollow fiber composite membranes. These processes include spin-dope preparation, a proprietary apparatus for dry-jet wet-spinning of microporous polysul-fone hollow fibers, coating of these fibers with a variety of permselective materials, bundle winding using multifilament yarns and module assembly. Modules of the membrane identified as Quantro II are in field trial against brackish and seawater feeds. Brackish water rejections of 94+% at a flux of 5-7 gfd at 400 psi have been measured. Seawater rejections of 99+% at 1-2 gfd at 1000 psi have been measured. Membrane use requires sealing of some portion of the fiber bundle for installation in a pressure shell. Much effort has been devoted to identification of potting materials which exhibit satisfactory adhesion to the fiber while... 

An alternative to the impingement plate is the annular distributor (Figure 6.33), which, through the use of a partial double shell, absorbs the impact of the inlet fluid jet and distributes the fluid more uniformly into the tube bundle. An annular distributor is designed to require a low-pressure... 

Armbruster and Mitrovic [62] observed that liquid falls from tube to tube in three patterns discrete droplets, jets or columns, and sheets, depending on the flow rate (i.e., film Reynolds number) and fluid properties. In addition, depending on the tube arrangement and spacing, the condensate may cause ripples, waves, and turbulence to occur in the film splashing may occur, as well as nonuniform rivulet runoff of condensate because of tube inclination or local vapor velocity effects. As a result, it is impossible to arrive at an analytical expression to describe these complex bundle phenomena. In general, the effect of inundation may be accounted for using... 

---