Jacobsen manganese asymmetric

The requirement for the presence of an adjacent alcohol group can be regarded as quite a severe limitation to the substrate range undergoing asymmetric epoxidation using the Katsuki-Sharpless method. To overcome this limitation new chiral metal complexes have been discovered which catalyse the epoxidation of nonfunctionalized alkenes. The work of Katsuki and Jacobsen in this area has been extremely important. Their development of chiral manganese (Ill)-salen complexes for asymmetric epoxidation of unfunctionalized olefins has been reviewed1881. 

As a solvent for the asymmetric epoxidation of 2,2-dimethylchromene mediated by Jacobsen s chiral (salen)-manganese catalyst.49... 

In the same year (1990) that Jacobsen reported his asymmetric epoxidation, a group led by Tsutomu Katsuki at the University of Kyushu in Japan reported a closely related asymmetric epoxidation. The chiral catalyst is also a salen and the metal manganese. The oxidant is iodosobenzene (Phl=0) but this method works best for E-alkenes. It is no coincidence that Katsuki and Jacobsen both worked for Sharpless. It is not unusual for similar discoveries to be made independently in different parts of the world, the Katsuki manganese salen complex... 

The applicability of the Sharpless asymmetric epoxidation is however limited to functionalized alcohols, i.e. allylic alcohols (see Table 4.11). The best method for non-functionalized olefins is the Jacobsen-Kaksuki method. Only a few years after the key publication of Kochi and coworkers on salen-manganese complexes as catalysts for epoxidations, Jacobsen and Kaksuki independently described, in 1990, the use of chiral salen manganese (111) catalysts for the synthesis of optically active epoxides [276, 277] (Fig. 4.99). Epoxidations can be carried out using commercial bleach (NaOCl) or iodosylbenzene as terminal oxidants and as little as 0.5 mol% of catalyst. The active oxidant is an oxomanganese(V) species. 

Asymmetric epoxidation The catalytic asymmetric epoxidation of alkenes has been the focus of many research efforts over the past two decades. The non-racemic epoxides are prepared either by enantioselective oxidation of a prochiral carbon-carbon double bond or by enantioselective alkylidenation of a prochiral C=0 bond (e.g. via a ylide, carbene or the Darzen reaction). The Sharpless asymmetric epoxidation (SAE) requires allylic alcohols. The Jacobsen epoxidation (using manganese-salen complex and NaOCl) works well with ds-alkenes and dioxirane method is good for some trans-alkenes (see Chapter 1, section 1.5.3). 

The report by Kochi and co-workers in 1986 that a (salen)manganese(lll) complex (Mn(salen) complex) was an efficient epoxidation catalyst for simple olefins <1986JA2309> quickly led to independent reports from the groups of Jacobsen <1990JA2801> and Katsuki <1990TL7345> that chiral Mn(salen) complexes could catalyze asymmetric epoxidation reactions. The reaction requires the use of a stoichiometric oxidant initially iodosylarenes were utilized, but it was quickly found that NaOCl was also successful. 

In this context it is worth noting that neither the titanium(IV) tartrate catalyst nor other metal catalyst-alkyl hydroperoxide reagents are effective for the asymmetric epoxidation of unfunctionalized olefins. The only system that affords high enantioselectivities with unfunctionalized olefins is the manganese(III) chiral Schiff s base complex/NaOCl combination developed by Jacobsen [42]. There is still a definite need, therefore, for the development of an efficient chiral catalyst for asymmetric epoxidation of unfunctionalized olefins with alkyl hydroperoxides or hydrogen peroxide. 

W. Zhang, E. N. Jacobsen, Asymmetric olefin epoxidation with sodium hypochlorite catalyzed by easily prepared chiral manganese(III) salen complexes, /. Org. Chem. 56 (1991) 2296. 

Between 2000 and 2005, several major reviews on asymmetric organic synthesis were published [10-14] which also covered some advances in the dynamic field of polymer-immobilized manganese-saien complexes. In 2000, immobilization of Jacobsen s epoxidation catalyst [26] on polystyrene and polymethacrylate resins was reported [27]. Catalytic performances were evaluated using 1,2-dihydronaphtha-lene, indene, l-phenyl-3,4-dihydronaphthalene and 1-phenylcyclohexene as substrates, and wx-chloroperbenzoic add (m-CPBA) and N-methylmorpholine-N-oxide (NMO) as oxidant/co-oxidant. Epoxide yields up to 61% and ee values up to 91%... 

Asymmetric epoxidation (AE) of unfunctionalized alkenes catalyzed by chiral (salen)Mn(III) complex 38 (Scheme 2.13), developed by Jacobsen et al., is one of the most reliable methods [50]. As shown in Table 2.2, several different strategies have been formulated to immobilize Jacobsen s catalysts on inorganic supports [37-42]. Facilitation of catalyst separation, catalyst reuse, an increase in catalyst stability (e.g. minimization of the possibility of formahon of inachve g-oxo-manganese(lV) species [51a,b]) and sometimes improvement in enanhoselectivity are the main objectives of such research. Heterogenized Mn(salen) systems have recently been reviewed by Salvador et al. [51c] and Garcia et al. [5 Id]. Some selected cases are therefore described herein on the basis of the immobilizahon methods. 

Polymer-supported salen catalysts were also developed by employing poly (norbornene)-immobihzed salen complexes 139 of manganese and cobalt (Scheme 3.40) [77]. The poly(norbornene) complexes are highly active and selective catalysts for the epoxidation of olefins. The asymmetric epoxidation of cis-P-methylstyrene 132 occurred smoothly at -20 °C to give the chiral epoxide 133 in 100% conversion with 92% ee. Under the same reaction conditions, Jacobsen s catalyst (an unsupported salen complex) afforded the same product with 93% ee. 

The catalyhc asymmetric epoxidation of alkenes offers a powerful strategy for the synthesis of enantiomerically enriched epoxides. Among the several existing catalyhc methods, the asymmetric epoxidahon of unfunctionalized alkenes catalyzed by chiral Mn(lll)(salen) complexes such as homochiral [( N.N )-bis(3,5-di-tert-butylsalicylidene)-l,2-cyclohexanediamine]manganese(lll) chloride (22) (Figure 7.7), as developed by Jacobsen and coworkers, represents one ofthe most reliable methods [39]. 

From the work of Jacobsen and Katsuki, it is known that chiral manganese salen complexes are excellent catalysts for the asymmetric epoxidation of alkenes... 

A similar (salen)manganese(III) catalyst was used by Katsuki for asymmetric sulfide oxidations [35]. Chiral complex 20 bears additional asymmetric carbons in the salicylidene part of the salen. In this system, hydrogen peroxide, which was the preferred oxidant in the Jacobsen procedure, turned out to be inefficient. Instead, iodosylbenzene was chosen, and in the presence of only 1 mol % of catalyst several aryl alkyl sulfides were oxidized in acceptable yields having enantiomeric excesses in the range of 8% to 90%. As in the Jacobsen-KatsuJd-epoxida-tion, the presence of additives such as pyridine N-oxide has a beneficial effect on chemical and optical yields. In addition, such co-ligands suppress the overoxidation of sulfoxides to the corresponding sulfones so that a sulfoxide sulfone ratio of 47 1 can be achieved. Consequentely, as shown for the case of thioanisole. 

Epoxides are key chiral synthetic intermediates and their enantioselective preparation by oxidation of achiral alkenes is a key reaction in many synthetic strategies. Sharpless asymmetric epoxidation is suitable for most allylic alcohols [26, 27], but few general procedures exist for unfunctionalized olefins. Jacobsen s manganese salen-mediated epoxidation is suitable for and gives good selectivities with Z-olefins (85 to 90% ee) [28]. The enzyme chloroperoxidase... 

---