Inorganic modified

By batch description trials Organo- and inorganically- modified zealot was subjected up to 24 hr in distilled water, tap water and 2% Nalco aqueous solutions in laboratory shaken machine to demonstrate how strongly the examined oxyanions are bound on the modified zeolite. While only slightly chromate desorption in the maximum extent about 20 mg/L was observed, approximately one order higher arsenate desorption was found, corresponding to increased ionic strength in waters. However, in both cases ODA-clinoptilolite exhibited the lowest desorption characteristics. Here, the... 

Reagents used in flotation, collectors, frothers, depressants, flocculants and inorganic modifiers can interact with each other in the flotation pulp and at the mineral-solution interface. The chemical equilibria involved in these interactions and the nature of the products will have a significant effect on their adsorption and the resultant flotation processes. 

Chem. Descrip. Inorganically modified/treated hydrogenated castor oil... 

Chem. Descrip. Castor oil inorganically modified deriv. 

In addition to polymer-polymer blends, there is interest in inorganic-modified polymers in the form of inorganic-organic hybrids. Fillers are often added to polymers to reduce costs and their influences on properties are often modest. Alternatively an aim can be to prepare polymer-ceramic composites with particular characteristics. 

Polymer electrolyte is composed of polymer substrate and metal salt. Possible polymer substrates include polyethylene oxide, poly vinylidene fluoride, poly(methyl methacrylate), polyvinylidene chloride, and polyacrylonitrile. Examples of cations of metal salt are li, Na, K, and Mg. Possible anions are BF, SCN, SO3CF3, AsF PF and NfCFjSOj). An inorganic modifier such as nanopartide Ti02 can be added to increase mechanical properties of supercapadtor. Mass is divided so that polymer substrate is 30 to 90 wt%, metal salt is to 2 to 30 wt%, and nanotube modifier is 3 to 30 wt%. 

A very high / ara-selectivity of inorganic-modified ZSM-5 was also manifested in the disproportionation of ethylbenzene. The results with ZSM-5 modified with magnesium and phosphorus compounds are shown in Table 4.10. The concentration of ara-isomer in the diethylbenzene products was over 99%. ... 

This last category of CMEs gathers all systems that cannot be classified into the above homogeneous layers. It mainly includes composite electrodes based on multicomponent heterogeneous matrices constituted by either (bio)organic ° or inorganic modifiers (mcludmg notably clays,... 

Wang M, loccozia J, Sun L et al (2014) Inorganic-modified semiconductor Ti02 nanotube arrays for photocatalysis. Energy Environ Sci 7 2182-2202... 

---