Important wetting geometries

Various correlations for mean droplet size generated by plain-jet, prefilming, and miscellaneous air-blast atomizers using air as atomization gas are listed in Tables 4.7, 4.8, 4.9, and 4.10, respectively. In these correlations, ALR is the mass flow rate ratio of air to liquid, ALR = mAlmL, Dp is the prefilmer diameter, Dh is the hydraulic mean diameter of air exit duct, vr is the kinematic viscosity ratio relative to water, a is the radial distance from cup lip, DL is the diameter of cup at lip, Up is the cup peripheral velocity, Ur is the air to liquid velocity ratio defined as U=UAIUp, Lw is the diameter of wetted periphery between air and liquid streams, Aa is the flow area of atomizing air stream, m is a power index, PA is the pressure of air, and B is a composite numerical factor. The important parameters influencing the mean droplet size include relative velocity between atomization air/gas and liquid, mass flow rate ratio of air to liquid, physical properties of liquid (viscosity, density, surface tension) and air (density), and atomizer geometry as described by nozzle diameter, prefilmer diameter, etc. 

The first task was to produce carriers from different recipes and in different shapes as shown schematically in Fig. 8. The raw materials diatomaceous earth, water and various binders are mixed to a paste, which is subsequently extruded through a shaped nozzle and cut off to wet pellets. The wet pellets are finally dried and heated in a furnace in an oxidising atmosphere (calcination). The nozzle geometry determines the cross section of the pellet (cf. Fig. 3) and the pellet length is controlled by adjusting the cut-off device. Important parameters in the extrusion process are the dry matter content and the viscosity of the paste. The pore volume distribution of the carriers is measured by Hg porosimetry, in which the penetration of Hg into the pores of the carrier is measured as a function of applied pressure, and the surface area is measured by the BET method, which is based on adsorption of nitrogen on the carrier surface [1]. 

As shown in the studies commented below, the most important about the mechanism of foam in EOR applications are the connectivity and geometry of medium (a size distribution of pore bodies of the order of 100 pm in diameter and pore-throats of the order of 10 pm in diameter) the distribution of the two-phase systems (liquid-gas) in pores which depends on the wetting of pore walls and the volume ratio of the liquid and gas phases the regulating capillary pressure the mode of foam generation and foam microstructure. 

Mass-Transfer Correlations Because of the tremendous importance of mass transfer in chemical engineering, a veiy large number of studies have determined mass-transfer coefficients both empirically and theoretically. Some of these studies are summarized in Tables 5-17 to 5-24. Each table is for a specific geometry or type of contactor, starting with flat plates, which have the simplest geometry (Table 5-17) then wetted wall columns (Table 5-18) flow in pipes and ducts (Table 5-19) submerged objects (Table 5-20) drops and... 

---