Hydrogen modulus

Properties Density Thickness Electrical Resistivity Corrosion Current Permeability for Hydrogen Modulus of Elasticity... 

Class and Chu demonstrated that if a tackifier is chosen that is largely incompatible with the elastomer, a modulus increase due to the filler effect is observed and little change in Ta results, and once again a PSA would not be obtained. This was observed for mixtures of low molecular weight polystyrene resin and natural rubber. The same polystyrene resin did tackify SBR, a more polar elastomer that is compatible with the resin. Hydrogenating the polystyrene to the cycloaliphatic polyvinylcyclohexane changed the resin to one now compatible with the less polar natural rubber and no longer compatible with SBR. These authors also provide... 

In the sol-gel procedure for the preparation of hybrids, polymeric acid catalysts such as poly (styrene sulfonic acid) were also used instead of hydrogen chloride [14]. The polymeric acid catalyst was effective for the preparation of hybrids at a similar level to that of hydrogen chloride catalyst. In some cases, the increased modulus was observed due to the higher extent of reaction. No difference was observed in morphologies between the hybrids prepared with polymeric and small molecule acid catalysts. The method using polymeric acid catalyst may depress the ion-conductive property, characteristic to the mobile acidic small molecules. Polymeric catalyst may also influence the rheology of the resulting hybrids. 

De Sarkar et al. [52] have reported a series of new TPEs from the blends of hydrogenated SBR and PE. These binary blends are prepared by melt mixing of the components in an internal mixer, such as Brabender Plasticorder. The tensile strength, elongation at break, modulus, set, and hysteresis loss of such TPEs are comparable to conventional rubbers and are excellent. At intermediate blend ratio, the set values show similarity to those typical of TPEs (Table 5.5). 

The reactor feed mixture was "prepared so as to contain less than 17% ethylene (remainder hydrogen) so that the change in total moles within the catalyst pore structure would be small. This reduced the variation in total pressure and its effect on the reaction rate, so as to permit comparison of experiment results with theoretical predictions [e.g., those of Weisz and Hicks (61)]. Since the numerical solutions to the nonisothermal catalyst problem also presumed first-order kinetics, they determined the Thiele modulus by forcing the observed rate to fit this form even though they recognized that a Hougen-Watson type rate expression would have been more appropriate. Hence their Thiele modulus was defined as... 

In cellulose II with a chain modulus of 88 GPa the likely shear planes are the 110 and 020 lattice planes, both with a spacing of dc=0.41 nm [26]. The periodic spacing of the force centres in the shear direction along the chain axis is the distance between the interchain hydrogen bonds p=c/2=0.51 nm (c chain axis). There are four monomers in the unit cell with a volume Vcen=68-10-30 m3. The activation energy for creep of rayon yarns has been determined by Halsey et al. [37]. They found at a relative humidity (RH) of 57% that Wa=86.6 kj mole-1, at an RH of 4% Wa =97.5 kj mole 1 and at an RH of <0.5% Wa= 102.5 kj mole-1. Extrapolation to an RH of 65% gives Wa=86 kj mole-1 (the molar volume of cellulose taken by Halsey in his model for creep is equal to the volume of the unit cell instead of one fourth thereof). 

---