Halide optical spectra

Only three general reviews on vanadium(IV) complexes have been given others deal with subnormal magnetic complexes, ESR spin probes,vanadium(IV) halides, optical spectra and phosphorus donor ligands, vanadium porphyrins and annual reviews for 1979, 1980 and 1981. 

The F-center is the most fundamental color center defect in the alkali halide lattice. Although it is not laser-active, the optical properties of the F-center are important in understanding the laser physics of other color center lasers. The fundamental absorption band of the F-center, called the F band, corresponds to a transition fi om the Is-like ground state to the 2p-like first excited state of the square-well potential. The F-band transition is very strong, and dominates the optical spectrum of the alkali-halide crystal. In fact, the term F-center comes fi om the German word Farbe, meaning color, and refers to the strong color imparted to the otherwise transparent alkali-halide crystals. 

Methods. All solutions were prepared to be ImM Cytochrome c, 0.1mM DCIP, 0.10M alkali halide, and 0.10M phosphate buffer at pH 7.0 or pD 7.0. The DCIP served as a mediator-titrant for coupling the Cytochrome c with the electrode potential. E° values were measured using a previously described spectropotentiostatic technique using an optically transparent thin-layer electrode (OTTLE) (7,11,12). This method involved incrementally converting the cytochrome from its fully oxidized to fully reduced state by a series of applied potentials. For each potential a spectrum was recorded after equilibrium was attained. The formal redox potential was obtained from a Nernst plot. The n value... 

Molecules in the second coordination sphere, that is, solvent or partners of an ion pair, can transfer charge to the metal ion of a coordination complex in an optically induced electronic transition. The excited states are, respectively, known as solvent to metal charge transfer (SMCT) and ion pair charge transfer (IPCT) excited states. A typical example are the ion pairs, [Cora(NH3)6]3 +, X-, formed between [Coln(NH3)6]3 + and halide and pseudohalide ions X. The UV-Vis spectrum of ion... 

By measurement of the wave length of the residual rays, for instance with a diffraction grating, it is possible to get a direct measurement of the maximum frequency in the optical band of the vibration spectrum of an alkali halide. If we treat the spectrum by the Debye method, regarding... 

The radical anion of molecular oxygen (O ) has been prepared and trapped in a range of alcohols, water and benzene but not in aliphatic hydrocarbons (Bennett et al., 1968a). In contrast to COg the e.s.r. spectrum shows that 0 interacts strongly with its immediate environment. This interaction which alters the separation of the upper molecular orbitals of the anion is strongly dependent on the nature of the matrix. Previously, the Oj" radical ion has been stabilized only in ionic materials such as the alkali halides thus it is of particular interest to find that this anion can be trapped successfully in a non-polar matrix (benzene). There is some evidence (Evans, 1961), from optical spectroscopic studies that molecular oxygen can form a weak charge transfer complex with the 77-electron system in benzene and it seems probable that O2 is stabilized in benzene by the formation of a similar complex. 

With the ever-increasing need to improve quality and productivity in the analytical pharmaceutical laboratory, automation has become a key component. Automation for vibrational spectroscopy has been fairly limited. Although most software packages for vibrational spectrometers allow for the construction of macro routines for the grouping of repetitive software tasks, there is only a small number of automation routines in which sample introduction and subsequent spectral acquisition/data interpretation are available. For the routine analysis of alkali halide pellets, a number of commercially available sample wheels are used in which the wheel contains a selected number of pellets in specific locations. The wheel is then indexed to a sample disk, the IR spectrum obtained and archived, and then the wheel indexed to the next sample. This system requires that the pellets be manually pressed and placed into the wheel before automated spectral acquisition. A similar system is also available for automated liquid analysis in which samples in individual vials are pumped onto an ATR crystal and subsequently analyzed. Between samples, a cleaning solution is passed over the ATR crystal to reduce cross-contamination. Automated diffuse reflectance has also been introduced in which a tray of DR sample cups is indexed into the IR sample beam and subsequently scanned. In each of these cases, manual preparation of the sample is necessary (23). In the field of Raman spectroscopy, automation is being developed in conjunction with fiber-optic probes and accompanying... 

---