Geochemical processes, time dependency

Mancktelow NS, Grasemann B (1997) Time-dependent effects of heat advection and topography on cooling histories during erosion. Tectonophysics 270 167-195 Niedermann S (2002) Cosmic-ray-produced noble gases in terrestrial rocks as a dating tool for surface processes. Rev Mineral Geochem 47 731-784... 

Electrokinetic remediation involves the installation of electrodes into multiple wells within a contaminated zone, followed by the application of a low electric potential. Ideally, the contaminants migrate toward the electrodes due to different transport mechanisms, and, upon reaching the wells, contaminant-laden liquids are extracted and treated. Although implementation is simple, the geochemical processes that occur within soils during electrokinetic remediation are complex and dependent on system variables such as soil type, pollutant type, treatment time, electrolyte solution, and applied voltage. 

While these calculations provide information about the ultimate equilibrium conditions, redox reactions are often slow on human time scales, and sometimes even on geological time scales. Furthermore, the reactions in natural systems are complex and may be catalyzed or inhibited by the solids or trace constituents present. There is a dearth of information on the kinetics of redox reactions in such systems, but it is clear that many chemical species commonly found in environmental samples would not be present if equilibrium were attained. Furthermore, the conditions at equilibrium depend on the concentration of other species in the system, many of which are difficult or impossible to determine analytically. Morgan and Stone (1985) reviewed the kinetics of many environmentally important reactions and pointed out that determination of whether an equilibrium model is appropriate in a given situation depends on the relative time constants of the chemical reactions of interest and the physical processes governing the movement of material through the system. This point is discussed in some detail in Section 15.3.8. In the absence of detailed information with which to evaluate these time constants, chemical analysis for metals in each of their oxidation states, rather than equilibrium calculations, must be conducted to evaluate the current state of a system and the biological or geochemical importance of the metals it contains. 

To this point, we have emphasized that the cycle of mobilization, transport, and redeposition involves changes in the physical state and chemical form of the elements, and that the ultimate distribution of an element among different chemical species can be described by thermochemical equilibrium data. Equilibrium calculations describe the potential for change between two end states, and only in certain cases can they provide information about rates (Hoffman, 1981). In analyzing and modeling a geochemical system, a decision must be made as to whether an equilibrium or non-equilibrium model is appropriate. The choice depends on the time scales involved, and specifically on the ratio of the rate of the relevant chemical transition to the rate of the dominant physical process within the physical-chemical system. 

The geochemical fate of most reactive substances (trace metals, pollutants) is controlled by the reaction of solutes with solid surfaces. Simple chemical models for the residence time of reactive elements in oceans, lakes, sediment, and soil systems are based on the partitioning of chemical species between the aqueous solution and the particle surface. The rates of processes involved in precipitation (heterogeneous nucleation, crystal growth) and dissolution of mineral phases, of importance in the weathering of rocks, in the formation of soils, and sediment diagenesis, are critically dependent on surface species and their structural identity. 

---