Free radical chain polymerization propagation rate constant

A case classically associated with radical chain polymerization for which a (pseudo)steady state is assumed for the concentration of active centers this condition is attained when the termination rate equals the initiation rate (the free-radical concentration is kept at a very low value due to the high value of the specific rate constant of the termination step). The propagation rate, is very much faster than the termination rate, so that long chains are produced from the beginning of the polymerization. For linear chains, the polydispersity of the polymer fraction varies between 1.5 and 2. 

The theory of radiation-induced grafting has received extensive treatment [21,131,132]. The typical steps involved in free-radical polymerization are also applicable to graft polymerization including initiation, propagation, and chain transfer [133]. However, the complicating role of diffusion prevents any simple correlation of individual rate constants to the overall reaction rates. Changes in temperamre, for example, increase the rate of monomer diffusion and monomer... 

Transfer constants for polystyrene chain radicals at 60° and 100°C, obtained from the slopes of these plots and others like them, are given in the second and third columns of Table XIII. Almost any solvent is susceptible to attack by the propagating free radical. Even cyclohexane and benzene enter into chain transfer, although to a comparatively small extent only. The specific reaction rate at 100°C for transfer with either of these solvents is less than two ten-thousandths of the rate for the addition of the chain radical to styrene monomer. A fifteenfold dilution with benzene was required to halve the molecular weight, i.e., to double l/xn from its value (l/ rjo for pure styrene (see Fig. 16). Other hydrocarbons are more effective in lowering the degree of polymerization through chain transfer. 

As mentioned in Section 9.3, Jackson (141) has obtained estimates of the chain-transfer coefficient of the growing radical with polymer in the free-radical polymerization of ethylene, C,p, by choosing the value so as to fit the MWD. As the polymerization conditions for the polymers mentioned in Table 10.1 are not disclosed, it is necessary to choose typical conditions 220° C and 2000 atm will be selected. Under these conditions Ctp, the ratio of the rate constant for attack on polymer (per monomer unit) to that for propagation, in a homogeneous phase, was found to be about 4.0 x 10 3. This is in good agreement with the known transfer coefficients for the lower alkanes (160), when allowance is made for the differences in pressure and temperature (100). The relation between Ctp and k is ... 

Comprehensive Models. This class of detailed deterministic models for copolymerization are able to describe the MWD and the CCD as functions of the polymerization rate and the relative rate of addition of the monomers to the propagating chain. Simha and Branson (3) published a very extensive and rather complete treatment of the copolymerization reactions under the usual assumptions of free radical polymerization kinetics, namely, ultimate effects SSH, LCA and the absence of gel effect. They did consider, however, the possible variation of the rate constants with respect to composition. Unfortunately, some of their results are stated in such complex formulations that they are difficult to apply directly (10). Stockmeyer (24) simplified the model proposed by Simha and analyzed some limiting cases. More recently, Ray et al (10) completed the work of Simha and Branson by including chain transfer reactions, a correction factor for the gel effect and proposing an algorithm for the numerical calculation of the equations. Such comprehensive models have not been experimentally verified. 

---