Frank nematics

Figure C2.2.11. (a) Splay, (b) twist and (c) bend defonnations in a nematic liquid crystal. The director is indicated by a dot, when nonnal to the page. The corresponding Frank elastic constants are indicated (equation(C2.2.9)).

Note 3 The names of Oseen, Zocher, and Frank are associated with the development of the theory for the elastic behaviour of nematics and so the elastic constants may also be described as the Oseen-Zocher-Frank constants, although the term Frank constants is frequently used. 

The three elastic constants are the Frank elastic constants, called after Frank, who introduced them already in 1958. They originate from the deformation of the director field as shown in Fig. 15.52. A continuous small deformation of an oriented material can be distinguished into three basis distortions splay, twist and bend distortions They are required to describe the resistance offered by the nematic phase to orientational distortions. As an example, values for Miesowicz viscosities and Frank elastic constants are presented in Table 15.10. It should be mentioned that those material constants are not known for many LCs and LCPs. Nevertheless, they have to be substituted in specific rheological constitutive equations in order to describe the rheological peculiarities of LCPs. Accordingly, the viscosity and the dynamic moduli will be functions of the Miesowicz viscosities and/or the Frank elastic constants. Several theories have been presented that are more or less able to explain the rheological peculiarities. Well-known are the Leslie-Ericksen theory and the Larson-Doi theory. It is far beyond the scope of this book to go into detail of these theories. The reader is referred to, e.g. Aciemo and Collyer (General References, 1996). 

Very few data exist for the viscosities or Frank constants of discotic nematics—that is, nematics composed of disc-Uke particles or molecules (Chandrasekhar 1992). One can estimate values of the Leslie viscosities from the Kuzuu-Doi equations (10-20) by setting the aspect ratio p equal to the ratio of the thickness to the diameter of the particles thus /j — 0 for highly anisotropic disks. This implies that R(p) —1, and Eq. (10-20b) implies that the viscosity o 2 is large and positive for discoidal nematics, while it is negative for ordinary nematics composed of prolate molecules or particles. If, as expected, is much smaller in magnitude than 0 2. the director (which is orthogonal to the disks) will tend... 

If a homeotropically aligned tumbling nematic is sheared at small Er = yxVh/K, then the director at the midplane of the sample rotates modestly toward the flow direction, until it reaches a steady state where the viscous forces driving the director rotation are balanced by the Frank stresses (see Fig. 10-16 at Er 1). As Er increases in small increments, so that a steady state is attained between each increment in Er, the steady-state director at the midplane is rotated to a greater and greater extent (see Fig. 10-16 at Er 10). 

Because nematic liquid-crystalline polymers by definition are both anisotropic and polymeric, they show elastic effects of at least two different kinds. They have director gradient elasticity because they are nematic, and they have molecular elasticity because they are polymeric. As discussed in Section 10.2.2, Frank gradient elastic forces are produced when flow creates inhomogeneities or gradients in the continuum director field. Molecular elasticity, on the other hand, is generated when the flow is strong enough to shift the molecular order parameter S = S2 from its equilibrium value 5 . (Microcrystallites, if present, can produce a third type of elasticity see Section 11.3.6.)... 

At low enough shear rates, polymeric nematics ought to obey the same Leslie-Ericksen continuum theory that describes so well the behavior of small-molecule nematics. The main difference is that polymers have a much higher molecular aspect ratio than do small molecules, which leads to greater inequalities in the the numerical values of the various viscosities and Frank constants and to much higher viscosities. 

Because of the difficulty with which polymeric nematic monodomains are prepared, there are few measurements of Leslie viscosities and Frank constants for LCPs reported in the literature. The most complete data sets are for PBG solutions, reported by Lee and Meyer (1990), who dissolved the polymer in a mixed solvent of 18% dioxane and 82% dichloromethane with a few percent added dimethylformamide. Some of these data, measured by light scattering and by the response of the nematic director to an applied magnetic field, are shown in Figs. 11-19 and 11-20 and in Table 11-1. While the twist constant has a value of around K2 0.6 x 10 dyn, which is believed to be roughly independent of concentration and molecular weight, the splay and bend constants ATj and K3 are sensitive to concentration and molecular weight. 

The radius a of the onions in the intermediate shear-rate regime of lyotropic smectics depends on shear rate, scaling roughly as a A similar texture size scaling rule is found in nematics (see Section 10.2.7) there it reflects a balance of shear stress r y against Frank elastic stress. In smectics, the two important elastic constants B and Ki have differing... 

The tendency of LCs to resist and recover from distortion to their orientation field bears clear analogy to the tendency of elastic solids to resist and recover from distortion of their shape (strain). Based on this idea, Oseen, Zocher, and Frank established a linear theory for the distortional elasticity of LCs. Ericksen incorporated this into hydrostatic and hydrodynamic theories for nematics, which were further augmented by Leslie with constitutive equations. The Leslie-Ericksen theory has been the most widely used LC flow theory to date. 

Only the most essential terms are taken into account, where k and kg are temperature-independent elastic constants. The quantity estimates the average nematic Frank elastic constant."... 

Fgi is the elastic Frank free energy which describes the slowly varying spatial distortions of the director the free energy density f i is a function of the elastic modes of deformation of a nematic liquid crystal and is given by [19,23]... 

Here nd are elastic constants. The first, is associated with a splay deformation, K2 is associated with a twist deformation and with bend (figure C2.2.11). These three elastic constants are termed the Frank elastic constants of a nematic phase. Since they control the variation of the director orientation, they influence the scattering of light by a nematic and so can be determined from light-scattering experiments. Other techniques exploit electric or magnetic field-induced transitions in well-defined geometries (Freedericksz transitions, see section (C2.2.4.1I [20, M]. 

---