Franck process

Franck J 1925 Elementary processes of photochemical reactions Trans. Faraday Soc. 21 536... 

The state may decay by radiative (r) or non-radiative (nr) processes, labelled 5 and 7, respectively, in Figure 9.18. Process 5 is the fluorescence, which forms the laser radiation and the figure shows it terminating in a vibrationally excited level of Sq. The fact that it does so is vital to the dye being usable as an active medium and is a consequence of the Franck-Condon principle (see Section 7.2.5.3). 

The ZEKE-PE process shown in Figure 9.50(c) can be modified as shown by changing the wavenumber Vj of the first laser to excite the molecule to an excited vibrational level of M. Then the Franck-Condon factors for the band system are modified. This can allow... 

Another conventional simplification is replacing the whole vibration spectrum by a single harmonic vibration with an effective frequency co. In doing so one has to leave the reversibility problem out of consideration. It is again the model of an active oscillator mentioned in section 2.2 and, in fact, it is friction in the active mode that renders the transition irreversible. Such an approach leads to the well known Kubo-Toyozawa problem [Kubo and Toyozava 1955], in which the Franck-Condon factor FC depends on two parameters, the order of multiphonon process N and the coupling parameter S... 

Table I. Distribution of Excited H2+ Produced by Franck-Condon Electron Impact Processes with 50-Volt Ionizing Electrons...

Rudolph, R., Francke, K.P. and Miessner, H. (2002) Concentration dependence of VOC decomposition by dielectric barrier discharges, Plasma Chem. Plasma Process. 220, 401-12. 

The cage effect described above is also referred to as the Franck-Rabinowitch effect (5). It has one other major influence on reaction rates that is particularly noteworthy. In many photochemical reactions there is often an initiatioh step in which the absorption of a photon leads to homolytic cleavage of a reactant molecule with concomitant production of two free radicals. In gas phase systems these radicals are readily able to diffuse away from one another. In liquid solutions, however, the pair of radicals formed initially are caged in by surrounding solvent molecules and often will recombine before they can diffuse away from one another. This phenomenon is referred to as primary recombination, as opposed to secondary recombination, which occurs when free radicals combine after having previously been separated from one another. The net effect of primary recombination processes is to reduce the photochemical yield of radicals formed in the initiation step for the reaction. 

Electronic transitions in a solute take place very fast, i.e., almost immediately in comparison with the movement of the molecules as a whole and vibrations of atoms in organic molecules. Hence, absorption and fluorescence can be denoted in Fig. 5 by vertical arrows, in accordance with Franck-Condon principle. Both these processes are separated by relaxations, which are intermolecular rearrangements of the solute-solvent system after the excitation. 

Developed into a power series in R 1, where R is the intermolecular separation, H exhibits the dipole-dipole, dipole-quadrupole terms in increasing order. When nonvanishing, the dipole-dipole term is the most important, leading to the Forster process. When the dipole transition is forbidden, higher-order transitions come into play (Dexter, 1953). For the Forster process, H is well known, but 0. and 0, are still not known accurately enough to make an a priori calculation with Eq. (4.2). Instead, Forster (1947) makes a simplification based on the relative slowness of the transfer process. Under this condition, energy is transferred between molecules that are thermally equilibriated. The transfer rate then contains the same combination of Franck-Condon factors and vibrational distribution as are involved in the vibrionic transitions for the emission of the donor and the adsorptions of the acceptor. Forster (1947) thus obtains... 

Certain features of light emission processes have been alluded to in Sect. 4.4.1. Fluorescence is light emission between states of the same multiplicity, whereas phosphorescence refers to emission between states of different multiplicities. The Franck-Condon principle governs the emission processes, as it does the absorption process. Vibrational overlap determines the relative intensities of different subbands. In the upper electronic state, one expects a quick relaxation and, therefore, a thermal population distribution, in the liquid phase and in gases at not too low a pressure. Because of the combination of the Franck-Condon principle and fast vibrational relaxation, the emission spectrum is always red-shifted. Therefore, oscillator strengths obtained from absorption are not too useful in determining the emission intensity. The theoretical radiative lifetime in terms of the Einstein coefficient, r = A-1, or (EA,)-1 if several lower states are involved,... 

In principle, refined and relatively reliable quantum-theoretical methods are available for the calculation of the energy change associated with the process of equation 2. They take into account the changes in geometry, in electron distribution and in electron correlation which accompany the transition M(1 fio) — M+ (2 P/-), and also vibronic interactions between the radical cation states. Such sophisticated treatments yield not only reliable predictions for the different ionization energies 7 , 77 or 7 , but also rather precise Franck-Condon envelopes for the individual bands in the PE spectrum. However, the computational expenditure of these methods still limits their application to smaller molecules. We shall mention them later in connection with examples where such treatments are required. 

In spectroscopy we may distinguish two types of process, adiabatic and vertical. Adiabatic excitation energies are by definition thermodynamic ones, and they are usually further defined to refer to at 0° K. In practice, at least for electronic spectroscopy, one is more likely to observe vertical processes, because of the Franck-Condon principle. The simplest principle for understandings solvation effects on vertical electronic transitions is the two-response-time model in which the solvent is assumed to have a fast response time associated with electronic polarization and a slow response time associated with translational, librational, and vibrational motions of the nuclei.92 One assumes that electronic excitation is slow compared with electronic response but fast compared with nuclear response. The latter assumption is quite reasonable, but the former is questionable since the time scale of electronic excitation is quite comparable to solvent electronic polarization (consider, e.g., the excitation of a 4.5 eV n — n carbonyl transition in a solvent whose frequency response is centered at 10 eV the corresponding time scales are 10 15 s and 2 x 10 15 s respectively). A theory that takes account of the similarity of these time scales would be very difficult, involving explicit electron correlation between the solute and the macroscopic solvent. One can, however, treat the limit where the solvent electronic response is fast compared to solute electronic transitions this is called the direct reaction field (DRF). 49,93 The accurate answer must lie somewhere between the SCRF and DRF limits 94 nevertheless one can obtain very useful results with a two-time-scale version of the more manageable SCRF limit, as illustrated by a very successful recent treatment... 

France. See also French Patent Office aquaculture production, 3 189t piezoelectric ceramics research, 1 708 regenerated cellulose fibers in, 11 249 Franck-Condon shift, 22 215 Frank-Caro cyanamide process, 17 292 Frankia species, in nitrogen fixation, 17 299... 

---