Fraction Basics

The tumorigenic effect of benzo[a]pyrene was retarded by the creosote oil, neutral distillate, neutral residue, and phenolic fractions. However, in three instances this effect was apparently related to skin damage associated with the treatments rather to a specific inhibitory effect. Only the phenolic fraction seemed to exhibit a primary antagonistic effect. Three other fractions (basic, neutral, and a low concentration of neutral distillate) exhibited apparent tumor promoting effects. 

In vapor-liquid equilibria, if one phase composition is given, there are basically four types of problems, characterized by those variables which are specified and those which are to be calculated. Let T stand for temperature, P for total pressure, for the mole fraction of component i in the liquid phase, and y for the mole fraction of component i in the vapor phase. For a mixture containing m components, the four types can be organized in this way ... 

For liquid-liquid separations, the basic Newton-Raphson iteration for a is converged for equilibrium ratios (K ) determined at the previous composition estimate. (It helps, and costs very little, to converge this iteration quite tightly.) Then, using new compositions from this converged inner iteration loop, new values for equilibrium ratios are obtained. This procedure is applied directly for the first three iterations of composition. If convergence has not occurred after three iterations, the mole fractions of all components in both phases are accelerated linearly with the deviation function... 

Figure 10.7 shows the basic tradeoff to be considered as additional feed and product materials are recovered from waste streams and recycled. As the fractional recovery increases, the cost of the separation and recycle increases. On the dther hand, the cost of the lost materials decreases. It should be noted that the raw materials cost is a net cost, which means that the cost of lost materials should be adjusted to either... 

In the heaviest fractions such as resins and asphaltenes (see article 1.2), metal atoms such as nickel and vanadium are found. They belong in part to molecules in the porphyrine family where the basic pattern is represented by four pyrrolic rings, the metal being at the center of this complex in the form Wi - or V0+ (< 3)... 

Europe) In 1890 Boisbaudran obtained basic fractions from samarium-gadolinium concentrates which had spark spectral lines not accounted for by samarium or gadolinium. These lines subsequently have been shown to belong to europium. The discovery of europium is generally credited to Demarcay, who separated the rare earth in reasonably pure form in 1901. The pure metal was not isolated until recent years. 

The basic premise of this method is that the magnitude of the detector output, as measured by hj for a particular fraction, is proportional to the weight of that component in the sample. In this sense the chromatogram itself presents a kind of picture of the molecular weight distribution. The following column entries provide additional quantification of this distribution, however. 

The two-dimensional carrier confinement in the wells formed by the conduction and valence band discontinuities changes many basic semiconductor parameters. The parameter important in the laser is the density of states in the conduction and valence bands. The density of states is gready reduced in quantum well lasers (11,12). This makes it easier to achieve population inversion and thus results in a corresponding reduction in the threshold carrier density. Indeed, quantum well lasers are characterized by threshold current densities as low as 100-150 A/cm, dramatically lower than for conventional lasers. In the quantum well lasers, carriers are confined to the wells which occupy only a small fraction of the active layer volume. The internal loss owing to absorption induced by the high carrier density is very low, as Httie as 2 cm . The output efficiency of such lasers shows almost no dependence on the cavity length, a feature usehil in the preparation of high power lasers. 

---