Fluorescence luminescent conjugated polymers

Indeed, spin statistics mandate that if the rates of reactions (1) and (2) are the same, then the nongeminate polaron pairs generated by carrier injection in OLEDs would yield 3 TEs for every SE. This SE/TE branching ratio is one of the most important factors suppressing the efficiency of OLEDs based on the fluorescent decay of SEs. However, recent studies suggest that in luminescent -conjugated polymers the rate of reaction (1) is higher than that of (2), so the yield of SEs is... 

Recent studies using P2 have shown that it can be used to optically amplify fluorescent DNA assays [74]. The method comprises two components (a) the light harvesting luminescent conjugated polymer P2 and (b) a probe oligonucleotide consisting of a peptide nucleic acid (PNA) labeled with a reporter dye... 

Ley and Schanze have also examined the luminescence properties of the polymers Pq, Pio> P25> and P50 in solution at 298 K, and in a 2-methyltetrahydro-furan solvent glass at 77 K. These spectroscopic studies reveal that fluorescence from the 71,71" exciton state is observed at Amax=443 nm, 2.80 eV in the polymers P0-P50 at 298 and 77 K, but the intensity and lifetime of the fluorescence is quenched as the mole fraction of Re in the polymers is increased. This indicates that the metal chromophore quenches the 71,71" state. The quenching is inefficient even when the mole fraction is large, suggesting that interchain diffusion of the 71,71" exciton is slow compared to its lifetime [70]. Phosphorescence from the 71,71" state of the conjugated polymer backbone is observed at > max=b43 nm, 1.93 eV in P10-P50 at 77 K, and emission at Amax=690 nm, 1.8 eV is assigned to the d7i(Re) 7i oiy MLCT transition. 

In another approach, a fluorescent conjugated polymer was used as the material for the preparation of a chemosensor to detect 2,4,6-trinitrotoluene (TNT) and its related nitroaromatic compounds. To this end, microparticles, made of three-dimensionally cross-linked poly(l,4-phenylene vinylene) (PPV) via emulsion polymerization, were synthesized [61]. This material was chosen due to its high fluorescence intensity and sensitivity to changes in its microenvironment. The chemosensor was exposed to vapour containing different amounts of TNT and quenching of the polymer luminescence at 560 nm was observed after excitation at 430 nm. The dependence of the fluorescence signal in response to the analyte was described by a modified Stem-Volmer equation that assumes the existence of two different cavity types. The authors proposed the modified Stem-Volmer equation as follows ... 

Long-lived photoluminescence, at 826 nm, is reported (t 15 (is) for thin films of the processable, -conjugated polymer, poly(3-hexylthio-phene) (93JA8447). Excitation of the n—n transition with 518 nm light (So >S ) yields only very weak luminescence of 826-nm light, even at 18 K. The emission is enhanced, to point where it can be observed at room temperature, when the excitation wavelength is 250 nm, but it is completely quenched by oxygen. Prompt fluorescence decays within... 

---