Flash review

There is another way to potentiaUy foUow proton kinetics in intact ROS and that is to use the early receptor potential (ERP) or the early receptor current (ERG). The ERP is a very fast potential/current evoked from oriented photoreceptors with bright flashes (reviewed in Cone and Pak and Sullivan and Shukla ). At room temperature, two phases can be easily observed for the ERP, a somewhat faster (sub msec) corneal negative R1 and a bit slower (1 to 10 msec) potential of opposite sign, R2. For rhodopsin, Cone showed that the kinetics of appearance of R2 and Meta II were identical within experimental error (this correlation was also reported by Spalink and Stieve " for bovine retinas at 37°C). This finding, along with R2 s temperature dependence, led Cone to propose that R2 was due to charge movements associated with the Meta-I-to-Meta-II transition. (R1 was similarly linked to the RH to Meta I transitions.)... 

Thioketenes can be prepared in several ways, from carboxyHc acid chlorides by thionation with phosphoms pentasulfide [1314-80-3] 2 5 ketene dithioacetals by -elimination, from l,2,3-thiadia2oles with flash pyrolysis, and from alkynyl sulfides (thioacetylenes). The dimeri2ation of thioketenes to 2,4-bis(alkyHdene)-l,3-dithietane compounds occurs quickly. They can be cleaved back pyrolyticaHy (63). For a review see Reference 18. 

Molecular orbital calculations indicate that cyclo C-18 carbyne should be relatively stable and experimental evidence for cyclocarbynes has been found [25], Fig. 3B. Diederich et al [25] synthesised a precursor of cyclo C-18 and showed by laser flash heating and time-of flight mass spectrometry that a series of retro Diels-Alder reactions occurred leading to cyclo C-18 as the predominant fragmentation pattern. Diederich has also presented a fascinating review of possible cyclic all-carbon molecules and other carbon-rich nanometre-sized carbon networks that may be susceptible to synthesis using organic chemical techniques [26]. 

A flash fire is the nonexplosive combustion of a vapor cloud resulting from a release of flammable material into the open air, which, after mixing with air, ignites. In Section 4.1, experiments on vapor cloud explosions were reviewed. They showed that combustion in a vapor cloud develops an explosive intensity and attendant blast effects only in areas where intensely turbulent combustion develops and only if certain conditions are met. Where these conditions are not present, no blast should occur. The cloud then bums as a flash fire, and its major hazard is from the effect of heat from thermal radiation. 

Savignac et al. [26] excellently reviewed this topic, but Aitken and coworkers investigated further the flash vacuum pyrolysis (FVP) of the )0-oxophosphorus ylides (Scheme 5). 

A quantitative review of the effects of thermal radiation, flash fires, and blast overpressure on people and buildings surrounding the site. 

In the laser flash method, the heat is put in by laser flash instead of electric current in the stepwise heating method mentioned above. Thus this method may be classified as a stepwise heating method. A two-layered laser flash method was developed by Tada et al. " The experimental method and the data analysis, including a case involving radiative heat flow, are described in detail in the review article by Waseda and Ohta. A thin metal plate is placed at the surface of a melt. A laser pulse is irradiated onto a metal plate of thickness / having high thermal conductivity. The sample liquid under the metal plate and the inert gas above the plate are designated as the third and first layers, respectively. The temperature of the second layer becomes uniform in a short time" and the response thereafter is expressed by... 

In a nice review of the preparative methods for silaaromatics, Maier221 suggested that the flash vacuum pyrolytic techniques that had been so useful for the monosilyl compound could be utilized to prepare 1,4-disila-benzene. Thermolysis of 1,4-disila-2,5-cyclohexadiene led to formation of... 

A joint between a mild steel valve screwed onto an aluminium pipe was leaking a resin-solvent mixture, and when the joint was tightened with a wrench, a flash fire occurred. This was attributed to generation of sparks by a thermite reaction between the rusted steel valve and the aluminium pipe when the joint was tightened [1]. Hazards involved in the use of aluminium-sprayed steel are reviewed [2],... 

It is not our intention in this section to provide a comprehensive review of flash photolysis of organometallic species rather, we summarize some key experiments which establish the timescales of different types of reactions. Understandably, much more work has been done on the flash photolysis of metal carbonyls in solution than in the gas phase, and so we begin with solution experiments. 

Most nitrile oxides are unstable, some of them are explosive. This fact hinders the study of their physical properties. Nevertheless, there are a number of publications concerning not only stable but also unstable nitrile oxides. In particular, mass spectral data for nitrile oxides among other unstable compounds containing an N+-X bond are summarized in a review (9). In such studies, the molecular ions must be generated using indirect procedures, including dissociative electron ionization, online flash-vacuum pyrolysis mass spectrometry, or ion-molecular reactions. Their characterization is mainly based on collisional activation and ion-molecular reactions. 

The purpose of this article is to review the results of transient low pressure studies of carbon monoxide oxidation over transition metal substrates. Particular emphasis is given to the use of in-situ electron spectroscopy, flash desorption, modulated beam and titration techniques. The strengths and weaknesses of these will be assessed with regard to kinetic insight and quantification. An attempt will be made to identify questions that are ripe for investigation. Although not limited to it, the presentation emphasizes our own work. A very recent review of the carbon monoxide oxidation reaction C l) will be useful to readers who are interested in a more comprehensive view. 

Ligand substitution reactions of NO leading to metal-nitrosyl bond formation were first quantitatively studied for metalloporphyrins, (M(Por)), and heme proteins a few decades ago (20), and have been the subject of a recent review (20d). Despite the large volume of work, systematic mechanistic studies have been limited. As with the Rum(salen) complexes discussed above, photoexcitation of met allop or phyr in nitrosyls results in labilization of NO. In such studies, laser flash photolysis is used to labilize NO from a M(Por)(NO) precursor, and subsequent relaxation of the non-steady state system back to equilibrium (Eq. (9)) is monitored spectroscopically. 

---