Feedback positive

Globe valves. Permissible stroke range 10% to 90% sliding stem gives the highest sensitivity, and the actuator stem feedback position more closely represents the final element position (but not for fouling or solids). 

Table 4.1. Stability properties of the steady state when /c > 0 in a model without feedback, positive or negative feedback of Ca2+ on IP3. In the negative feedback, for fast IP3 dynamics, the steady state is stable when fpWc — fcUip < 0.

Control of Endocrine Activity Feedback Control of Hormone Production Negative Feedback Positive Feedback Pulsatile and Rhythmic Endocrine Control ... 

Reward correct performance. There are many forms of feedback. Positive is generally better than negative. Use praise and verbal comments when trainees do things correctly. Accurate and immediate feedback is better than delayed and general feedback. 

Lower mass elements with low absorption cross sections can yieid negative feedback Positive effects are reactivity iimited... 

Owing to the oscillatory force profile caused by the hydration layers, there is more than one stable tip position for the tip-sample distance regulation, as indicated by the dotted line in Fig. 18.8a. Consequently, the tip jumps between these feedback positions during the imaging, as shown in Fig. 18.8b. In the image, the tip was scanned from the lowest terrace (Terrace 1) corresponding to... 

When there is a dual set of solutions to the steady state equations as one set is established, the resulting concentration changes may cause a change to the other set. At no time is AG >0. For a sequence A->X->B- C, if A->X is autocatalytic but inhibited by B and if there is a delay between the two processes, concentration oscillations may be observed. Oscillation depends on two feedbacks positive i.e. catalytic and negative i.e. inhibitory. 

Each of the motors is connected to the power source through two normally open relays. One of these relays, if closed, will rotate the motor clockwise, while the other, if closed, will rotate the motor counterclockwise. Thirteen air pressure lines, a 24-volt DC power line, an electrical ground and a 25 pin computer cable are channeled through a rubber hose, 38mm in diameter which is fitted to the robot. The computer cable is used to transmit signals to the relays which control the motors and also receives the feedback position signals from the robot. 

---