Extracted flake products white flakes

After the completion of the reaction, the solution was acidified to a pH of 4 with 2N sulfuric acid, followed by the addition of 50 ml of water. The solution was then extracted several times with ether. The extractant was dried over magnesium sulfate and the solvent was removed by evaporation at reduced pressure. Cold petroleum ether was then added to the resultant oily material to precipitate the product. The product was further washed with cold (10° C) petroleum ether and recrystallized several times from warm petroleum ether. The melting point of the final product was 73.5° C. Infrared spectrum of the product showed major absorption peaks relevant to the pure monomer (Figure 1). Under UV radiation, white flakes of the monomer solid turned deep blue (partial polymerization). 

The crude ester is cooled, an equal volume of benzene is added, then the free acid is neutralized by shaking with about 250 cc. of a 10 per cent solution of sodium carbonate (Note 4). The benzene solution is poured into 1300 cc. of a saturated solution of sodium bisulfite (about 60 g. of technical sodium bisulfite per 100 cc.), contained in a wide-neck bottle equipped with an efficient stirrer, and the mixture stirred for two and a half hours. The mixture soon warms up a little and becomes semi-solid. It is filtered through a 20-cm. Buchner funnel and carefully washed, first with 200 cc. of a saturated solution of sodium bisulfite, finally with two 150-cc. portions of benzene (Notes 5 and 6). The white pearly flakes of the sodium bisulfite addition product are transferred to a 3-I. round-bottom wide-neck flask equipped with a mechanical stirrer and containing 700 cc. of water, 175 cc. of concentrated sulfuric acid, and 500 cc. of benzene. The flask is heated on a steam bath under a hood, the temperature being kept at 55°, and the mixture is stirred for thirty minutes (Note 7). The solution is then poured into a separatory funnel, the benzene separated and the water layer extracted with a 200-cc. portion of benzene. The combined benzene solution is shaken with excess of 10 per cent sodium carbonate solution to remove free acid and sulfur dioxide (Note 8). The benzene is washed with a little water and then dried over anhydrous potassium carbonate (Note 9). The benzene is distilled at ordinary pressure over a free flame from a 500-cc. Claisen flask, the solution being added from a separatory funnel as fast as the benzene distils. It is advisable to distil the ester under reduced pressure although it can be done under ordinary pressure. The fraction distilling around n8°/5mm., 130710 mm., 138715 mm., 148725 mm., 155735 mm., or... 

---