EMISSIONS SPECIFIC

Material Density, kg/nP Emissivity Specific heat, kJ/(kg-K) Thermal conductivity, W/(m-K) Thermal diffusivity, mVs X lO "... 

Emissions and inventories are in the case of air pollution related to the assessment of the level of pollutants released from various sources. That is to say emission specification of the relevant technologies and pollutants. The determination of emission factors of different substance in WEEE road transport is often the product of national, EU and international research. 

The following factors may increase N2O emissions, specifically in organic farming systems (Piorr and Werner 1998) ... 

Special process and product specifications have been set forth for companies in the chemical industry. Additionally, specific limits must be observed for pollutant or VOC (volatile organic compounds) emissions. Specific maximum allowable concentrations at workplaces must not be exceeded. Both the transport of chemicals and the recycling or disposal of chemical wastes are subject to particular requirements. Periodic hazard assessments - which in Germany, for example, are mandatory according to the Ordinance on Industrial Safety and Health (Betriebssicherheitsverordnung, BetrSichV) - are a must requirement in the chemical industry. To achieve a Continuous Improvement Process, product and process requirements must be identified, evaluated and monitored on a regular basis. 

Finally, the low-sulfur char is used as a clean boiler fuel for electric power generation. The hot char can be used directly, at pressure, with obvious advantages in thermal efficiency by using a pressurized, fluidized-bed combustion system (PFBC). The size consist of the char should ensure good performance when fluidized in the PFBC. Because the char has been partially desulfurized, the flue gas can easily meet a S02 emission specification of less than 0.8 lb per 106 Btu without the need to add limestone. This is in contrast to burning the Wyodak feed coal in a... 

The stringent R-MACT control specifications have been developed over a long period of time (more than 15 years) and refiect a compromise between what is possible and what is desirable in order to protect pubhc health while allowing improvements of valuable technologies. The emission specifications for each component and especially for the 210 congeners of chlorinated dioxins and furans were arrived at after completion of a great deal of research and mai r medical and epidemiological assessments of possible harm done by emissions to the air and/or water by these compounds. These studies have not yet been concluded. 

Rao, D.B.N., "The Effect of Crystallinity of Limestone and Particle Size Distribution of Kiln Feed on the Dust Emission, Specific Power Consumption and Clinker Quality," Proceedings of the 10th International Conference on Cement Microscopy, International Cement Microscopy Association, San Antonio, Texas, 1988, pp. 152-176. 

Hence the 736 nm emission does not appear to be an emission specific to PSI only. 

---