Electrolytic methods solvents

The foremnner of the modern methods of asphalt fractionation was first described in 1916 (50) and the procedure was later modified by use of fuller s earth (attapulgite [1337-76-4]) to remove the resinous components (51). Further modifications and preferences led to the development of a variety of fractionation methods (52—58). Thus, because of the nature and varieties of fractions possible and the large number of precipitants or adsorbents, a great number of methods can be devised to determine the composition of asphalts (5,6,44,45). Fractions have also been separated by thermal diffusion (59), by dialysis (60), by electrolytic methods (61), and by repeated solvent fractionations (62,63). 

Partially successful attempts towards chiral electrochemical synthesis have involved chiral supporting electrolytes chiral solvents and chiral adsorbates, mostly alkaloids With the latter method enantiometric excess values >40% have... 

With conventional techniques and electrolytes, it was not possible to obtain living anions because they are rapidly protonated by tetraalkylammonium salts and residual water. The first report of the production of living polymers by an electrolytic method has to be attributed to Yamazald et al. [247], who used tetrahydrofuran as solvent, and LiAlH4 or NaAl(C2H5)4 as electrolyte for the polymerization of a-methylstyrene. A similar technique was used to polymerize styrene as well as derivatives [248-252]. 

An example that demonstrates the possibilities inherent in the Hg cathode —(C4H9)4N + electrolyte method, for the preparation of products which are inaccessible by other methods, is found in the reduction of diphenyl ether 12). The only products of 12 from reduction with alkali metals in liquid NH3, amine solvent or HMPA 43b-e) were phenol and benzene, presumably arising from cleavage at the radical anion stage. Similarly phenol and benzene were formed by cathodic reduction... 

The method for obtaining osmotic coefficients of electrolytes from solvent activities is shown in Section lI.E. 

The propionamide can be dried over CaO. H2O and unreacted propionic acid were removed as their xylene azeotropes. It was vacuum dried. Material used as an electrolyte solvent (specific conductance less than 10 ohm cm" ) was obtained by fractional distn under reduced pressure, and stored over BaO or molecular sieves because it readily absorbs moisture from the atmosphere on prolonged storage. [Hoover Pure Appl Chem 37 581 I974 Recommended Methods for Purification of Solvents and Tests for Impurities, Coetzee Ed., Pergamon Press, 1982.]... 

---