Electric motor systems alternating current

This is a very good motor for direct connection to certain loads, particularly where constant speed is required. NEMA defines it as a synchronous machine which transforms electrical power from an alternating-current system into mechanical power. It usually has direct-current field excitation by a separately driven direct-current generator or one directly connected to the motor. This motor remains synchronous with the supply frequency and is not affected by the load. Proper application requires consideration of the following ... 

Electrical System. The conductors in the hose-cable carry power and control signals down to the underwater vehicle and return information. The drive-pump motor is powered by three-phase, 220 V carried down three paired conductors. The solenoid valve, which controls the clean pump, is energized by 24 V direct current (DC), which is controlled on deck. The submersible pump that circulates water through in situ sensors uses 110 V alternating current (AC) power from the hose-cable. 

Most electronic equipment shares the television set s need for a number of differing voltages for the operation of individual components. This alone may be sufficient justification for the inclusion of a direct current to alternating current converter in fuel cell power systems. In addition, alternating current electric motors are more suitable in most applications. They tend to operate at a rotational speed controlled by the frequency of the current. If completely unloaded they speed up to this fixed velocity and accelerate no further. Many types of direct current motors, if operated unloaded, will continue to accelerate until they fail. A belt driven fan operated by an alternating current motor is undamaged by the failure of the belt. A direct current motor will require a special safety circuit to shut it down in case of belt failure. If the belt and the safety circuit both fail, the motor will speed up until it destroys itself. 

Electric current sensors (potential-free sensors, e.g., for alternators, electric motors, and starters or for battery power management in future 42-V systems). 

Extruder motors are usually electric, but some systems utilize hydraulic motors. For example, injection molding machines use hydraulics to develop clamp tonnage. Electric motors may be of the direct current (DC) or alternating current (AC) types. Traditionally, DC motors, which regulate speed through voltage control, have been more popular because they could provide the necessary power at a lower cost. However, recent advances in frequency control - the technique used to regulate speed in AC motors - have caused this type of motor to become more widely used. 

---