Mud, drilling

Clays have layers of linked (Al, Si)04 tet-rahedra combined with layers of Mg(OH)2 or AI(0H)3- Clays are very important soil constituents and are used in pottery, ceramics, as rubber, paint, plastic and paper fillers, as adsorbents and in drilling muds. 

Solids materials that are insoluble in hydrocarbon or water can be entrained in the crude. These are called bottom sediments and comprise fine particles of sand, drilling mud, rock such as feldspar and gypsum, metals in the form of minerals or in their free state such as iron, copper, lead, nickel, and vanadium. The latter can come from pipeline erosion, storage tanks, valves and piping systems, etc. whatever comes in contact with the crude oil. 

An important safety feature on every modern rig is the blowout preventer (BOP). As discussed earlier on, one of the purposes of the drilling mud is to provide a hydrostatic head of fluid to counterbalance the pore pressure of fluids in permeable formations. However, for a variety of reasons (see section 3.6 Drilling Problems ) the well may kick , i.e. formation fluids may enter the wellbore, upsetting the balance of the system, pushing mud out of the hole, and exposing the upper part of the hole and equipment to the higher pressures of the deep subsurface. If left uncontrolled, this can lead to a blowout, a situation where formation fluids flow to the surface in an uncontrolled manner. 

Some clay minerals may absorb some of the water contained in the drilling mud. This will cause the clays to swe//and eventually reduce the borehole size to the point where the drill pipe becomes stuck. Prevention mud additives which prevent clay swelling e.g. potassium salt. 

During drilling operations sometimes large volumes of drilling mud are lost into a formation. In this case normal mud circulation is no longer possible and the fluid level inside the borehole will drop, creating a potentially dangerous situation as described below. The formations in which lost circulation can be a problem are ... 

Carbon black Pastes Cosmetics Polymer solutions Drilling muds Protein solutions Fog Soils... 

Drilling fluids Drilling glass Drilling mud additives Drillingmuds... 

ALCOHOLS,HIGHERALIPHATIC-SURVEY AND NATURALALCOHOLSMANUFACTURE] (Voll) -for drilling mud bentonites PETROLEUM - DRILLING FLUIDS] (Vol 18)... 

Polyacrylamides are used in many other oilfield appUcations. These include cement additives for fluid loss control in well cementing operations (127), viscosity control additives for drilling muds (128), and fracturing fluids (129). Copolymers [40623-73-2] of acrylamide and acrylamidomethylpropanesulfonic acid do not degrade with the high concentrations of acids used in acid fracturing. 

Petroleum and Natural Gas. Over 90% of the 428,000 t of caustic soda used in the petroleum and natural gas industry is used to process oil and gas into marketable products, especially by removing acidic contaminants. The remainder is used primarily to decrease corrosion of drilling equipment and to increase the solubiUty of drilling mud components by maintaining an alkaline pH (6). 

Welan has similar properties to xanthan gum except that it has increased viscosity at low shear rates and improved thermal stabiUty and compatibihty with calcium at alkaline pH (90). The increased thermal stabiUty has led to its use as a drilling mud viscosifter especially for high temperature weUs. The excellent compatibihty with calcium at high pH has resulted in its use in a variety of specialized cement and concrete appHcations. 

---