Dispersion high speed disperser

The previous investigations of hard particle transport processes during laser beam dispersing have shown, that the high speed microfocus radioscopy system is a usable arrangement to observe and analyse the movements, velocities and accelerations of particles inside the molten bath. That possibility was, until now, not given by conventional techniques of process... 

The investigations show that the microfocus high speed radioscopy system is suitable for monitoring the hard particle transport during laser beam dispersing. It is possible to observe and analyse the processes inside the molten bath with the presented test equipment. As a consequence a basis for correlation with the results of a simulation is available. 

Rubber-mill chips are dissolved similarly to resins, to provide color concentrates. Dough mixer and chip concentrates must be diluted with solvent and other vehicles to make finished inks. Media milling is becoming a method of choice in both flexo and gravure ink manufacturing. Other high speed dispersing units, such as the Morehouse, Cowles, Kady, and others, are also used. 

Thermal or Flame Spray Process. The earliest experiments in metal spray used molten metal fed to a spray apparatus, where it was dispersed by a high speed air jet into tiny droplets and simultaneously blown onto the surface of the part to be covered. The metal solidified on contact. Modem processes use a more convenient source than premelted metal. Spray heads using a flame or an electrical arc to melt metal wires or powders directly are much more convenient. These are the only types used on a large scale in the United States. 

High Speed Fluid Energy Mills. This type of equipment is used primarily for preparation of relatively low viscosity mill bases for inks and paints. The first is an impeller type which achieves dispersion by the appHcation of shear. The second type is in the form of a rotor—stator, and the dispersion is achieved by impingement or impact. 

Technical data. Fundamentals of High Speed Dispersion, Myers Engineering Inc., BeU, Calif. 

The Stratford Engineering Company s (Kansas City, Missouri) continuous SO organic mist sulfonation uses a high speed atomizing rotor to horizontally disperse the organic feedstock stream impinging on the reactor walls in the presence of SO gas to effect sulfonation of petroleum feedstocks (290). 

MiUs employed for dispersion and colloidal operations operate on the principle of high-speed flmd shear. They produce dispersed droplets of fine size, around 3 to 5 [Lm. 

---