Directed meta-metalation

Fig. 15 Examples of directed meta-metalation executed by a sodium zincate base...

The influence of two meto-interrelated DMGs can be concerted to direct the metalation in between them. LTMP metalates meta-znmc acid 9 in THF at 0°C at the doubly activated position (C2) [62]. The regiochemistry of this lithiation is truly thermodynamically controlled resonance and inductive effects favor removal of the H2 proton. LICKOR deprotonates preferentially the C4 position. To prepare 6-substituted benzoates, one has to (i) protect the C2 site by introducing a trimeth-ylsilyl group with LTMP, (ii) lithiate with s-BuLi/TMEDA, (iii) quench with an electrophile, and (iv) remove the protecting group in C2. 

Boron trioxide is not particularly soluble in water but it slowly dissolves to form both dioxo(HB02)(meta) and trioxo(H3B03) (ortho) boric acids. It is a dimorphous oxide and exists as either a glassy or a crystalline solid. Boron trioxide is an acidic oxide and combines with metal oxides and hydroxides to form borates, some of which have characteristic colours—a fact utilised in analysis as the "borax bead test , cf alumina p. 150. Boric acid. H3BO3. properly called trioxoboric acid, may be prepared by adding excess hydrochloric or sulphuric acid to a hot saturated solution of borax, sodium heptaoxotetraborate, Na2B407, when the only moderately soluble boric acid separates as white flaky crystals on cooling. Boric acid is a very weak monobasic acid it is, in fact, a Lewis acid since its acidity is due to an initial acceptance of a lone pair of electrons from water rather than direct proton donation as in the case of Lowry-Bronsted acids, i.e. 

Precious Meta.1 Ca.ta.lysts, Precious metals are deposited throughout the TWC-activated coating layer. Rhodium plays an important role ia the reduction of NO, and is combiaed with platinum and/or palladium for the oxidation of HC and CO. Only a small amount of these expensive materials is used (31) (see Platinum-GROUP metals). The metals are dispersed on the high surface area particles as precious metal solutions, and then reduced to small metal crystals by various techniques. Catalytic reactions occur on the precious metal surfaces. Whereas metal within the crystal caimot directly participate ia the catalytic process, it can play a role when surface metal oxides are influenced through strong metal to support reactions (SMSI) (32,33). Some exhaust gas reactions, for instance the oxidation of alkanes, require larger Pt crystals than other reactions, such as the oxidation of CO (34). 

Perfluoroalkylation can be accomplished via direct reaction of peifluoroalkyl halides and copper with aromatic substrates [232, 233, 234, 235, 236] Thus, perfluoroalkyl iodides or bromides react with functionalized benzenes m DMSO m the presence of copper bronze to give the corresponding perfluoroalkylated products directly in moderate to good yields [233] (equation 157) Mixtures of ortho, meta, and para isomers are obtained [232, 233], The use of acetic anhydride as solvent gives similar results [234, 235], Similarly, the direct reaction of perfluoroalkyl iodides and pyrroles with copper metal regiospecifically gives the 2-perfluoroalkylpyrroles [236] (equation 158). 

The most famous mechanism, namely Cossets mechanism, in which the alkene inserts itself directly into the metal-carbon bond (Eq. 5), has been proposed, based on the kinetic study [134-136], This mechanism involves the intermediacy of ethylene coordinated to a metal-alkyl center and the following insertion of ethylene into the metal-carbon bond via a four-centered transition state. The olefin coordination to such a catalytically active metal center in this intermediate must be weak so that the olefin can readily insert itself into the M-C bond without forming any meta-stable intermediate. Similar alkyl-olefin complexes such as Cp2NbR( /2-ethylene) have been easily isolated and found not to be the active catalyst precursor of polymerization [31-33, 137]. In support of this, theoretical calculations recently showed the presence of a weakly ethylene-coordinated intermediate (vide infra) [12,13]. The stereochemistry of ethylene insertion was definitely shown to be cis by the evidence that the polymerization of cis- and trans-dideutero-ethylene afforded stereoselectively deuterated polyethylenes [138]. 

Low-temperature 31P NMR studies showed that the reaction of (PCP)Ir with nitrobenzene leads to three products of the type (PCP)Ir(aryl)H and meta- and /> ra-additions are kinetically favored. However, refluxing the trans-isomer afforded the f-product, designated the thermodynamic product. Nevertheless, chelation to the metal still remains an important regiochemical factor in these reactions, which will be termed chelation controlled or directed hereafter.92... 

A flexible means of access to functionalized supports for solid-phase synthesis is based on metallated, cross-linked polystyrene, which reacts smoothly with a wide range of electrophiles. Cross-linked polystyrene can be lithiated directly by treatment with n-butyllithium and TMEDA in cyclohexane at 60-70 °C [1-3] to yield a product containing mainly meta- and para-Iithiated phenyl groups [4], Metallation of noncross-linked polystyrene with potassium ferf-amylate/3-(lithiomethyl)heptane has also been reported [5], The latter type of base can, unlike butyllithium/TMEDA [6], also lead to benzylic metallation [7]. The C-Iithiation of more acidic arenes or heteroar-enes, such as imidazoles [8], thiophenes [9], and furans [9], has also been performed on insoluble supports (Figure 4.1). These reactions proceed, like those in solution, with high regioselectivity. 

Kambara and Nishimura studied the hydrogenation of the methyl esters of o-, m-, and p-methoxybenzoic acid over platinum group metals in f-butyl alcohol at 60°C and atmospheric hydrogen pressure.197 As seen from the results shown in Table 11.15, hydrogenolysis occurred most extensively over platinum and iridium and much less extensively over rhodium and ruthenium, especially with the meta and para isomers. It is noted that the ortho isomer was hydrogenolyzed as extensively as the meta isomer over platinum and iridium, and much more extensively than the meta and para isomers over rhodium and ruthenium. Over Pd-C the most extensively hydrogenolyzed was the meta isomer. One of the reasons for the extensive hydrogenolysis in the case of the ortho isomer can be attributed to the direct formation of methyl benzoate, which amounted to 17.1% over rhodium, 20.7% over ruthenium, and 16.6% over platinum,... 

Activation of aromatic compounds by transition-metal complexes was initially studied with Cr(CO)3 complexes. Nucleophilic addition of 2-lithio-l,3-dithianes to arene-chromium(O) complexes 185 followed usually by iodine-promoted decomplexation affords the corresponding 2-arylated 1,3-dithianes 186. The reaction of //-(toluene)- and (anisole)tricarbonylchromium (185) with compound 161 gave mixtures (52 46 and 10 90, respectively) of ortho and meta substituted derivatives (186) (Scheme 54)244. The meta directing effect was also observed (mainly better than 95%) with amino and fluoro substituted complexes245. 

---