Dimensional limits

Inside surfaces of pipe component ends to be joined in butt or miter groove welds shall be aligned within the dimensional limits in the WPS and engineering design. 

While significant evidence supporting the notion of dual phase continuity was obtained, particularly from modulus-composition studies, no direct observation had been successful with TEM due to its two-dimensional limitation. 

The code requires internal ahgnment within the dimensional limits specified in the welding procedure and the engineering design without specific dimensional hmitations. Internal trimming is permitted... 

Namatsu H, Kurihara K, Nagase M, Iwadate K, Murase K (1995) Dimensional limitations of silicon nanolines resulting from pattern distortion due to sirnface tension of rinse water. Appl Phys Lett 66(20) 2655-2657... 

FIGURE 28 A three-dimensional limit-cycle and Poincare map. 

A crossbar architecture (Figs. 7(b) and (c)) has four advantages over other circuit design concepts in nano-electronics (i) the architecture is easily scalable at least up to the point where the dimensional limits of the Boltzmann electron transport regime begin, (ii) it requires only 2N... 

The consideration of the sets of mutually self-avoiding walkers has a wider import in revealing a fundamental invariant (the number of walkers) which turns out to be important in transfer-matrix solutions, as applied to polymer graphs extending even to the 2-dimensional limit [141,142]. Also this invariant or "order" has physical implications [71,72,84,85,152]. 

FIG. 14 Phase diagram of a system of hard-spheres between two parallel walls. In the three-dimensional limit (/c -> oo) the system is fluid-like for 3D < 0.5. When the walls separation is comparable to the particles size (/c 1) the system can undergo disorder-order phase transition. Adapted from Chavez-Paez et al. [39]. 

In the one-dimensional limit, the coupling to acoustic phonons is at the heart of the Su-Schrieffer-Heeger (SSH) Hamiltonian [21] ... 

The diffuser must be made from an oxygen compatible material. Brass, copper, or monel materials are good choices. Diffusers are frequently made from stainless steel, but in these cases dimensional limits, pressure limits, and velocity limits must be considered. 

Commonly used for temperature, pressure, time, and dimensional limitations. Up to" means from zero to the top limit at least" means not less than (does not set upper limit, which must be fully disclosed in specification) specification must support eventual ranges. A dependent claim cannot broaden the range. Range within range is indefinite in a claim, but acceptable in specification. 

---