Deuterated employing

Equation (5) was examined by Scott and Reese [1] employing mixtures of nitrobenzene and fully deuterated nitrobenzene as the test sample. Their retention times were 8.927 min. and 9.061 min., respectively, giving a difference of 8.04 seconds. The separation ratio of the two solutes was 1.023 and the efficiencies of the front and rear portions of the peaks were 5908 and 3670 theoretical plates, respectively. The detector was, not surprisingly, found to have the same response to both solutes, i.e., a = (3. Thus, inserting these values in equation (5),... 

This last result bears also on the mode of conversion of the adduct to the final substitution product. As written in Eq. (10), a hydrogen atom is eliminated from the adduct, but it is more likely that it is abstracted from the adduct by a second radical. In dilute solutions of the radical-producing species, this second radical may be the adduct itself, as in Eq. (12) but when more concentrated solutions of dibenzoyl peroxide are employed, the hydrogen atom is removed by a benzoyloxy radical, for in the arylation of deuterated aromatic compounds the deuterium lost from the aromatic nucleus appears as deuterated benzoic acid, Eq. (13).The over-all reaction for the phenylation of benzene by dibenzoyl peroxide may therefore be written as in Eq, (14). 

The deuterium line of the deuterated solvent is used for this purpose, and, as stated earlier, the intensity of this lock signal is also employed to monitor the shimming process. The deuterium lock prevents any change in the static field or radiofrequency by maintaining a constant ratio between the two. This is achieved via a lock feedback loop (Fig. 1.10), which keeps a constant frequency of the deuterium signal. The deuterium line has a dispersion-mode shape i.e., its amplitude is zero at resonance (at its center), but it is positive and negative on either side (Fig. 1.11). If the receiver reference phase is adjusted correcdy, then the signal will be exactly on resonance. If, however, the field drifts in either direction, the detector will... 

Both MS and NMR coupling to HPLC have been employed for the analysis of p-carotene isomers and determination of lutein and zeaxanthin isomers in spinach, sweet com, and in retina. Capillary high performance hquid chromatography with stop flow connected to NMR (600 MHz) was used for stracture elucidation of all-trans deoxylutein 11 and its isomers.Efforts are in progress to eliminate the remaining major drawbacks such as obligatory use of deuterated solvents in the mobile phase, poor sensitivity, and low throughput of HPLC-NMR analyses. 

When [ H]-labeled precursors are employed the resulting compounds can be used as internal standards for analysis, especially by utilization of mass spectrometric methods. Appropriate deuterated standards are shown in Fig. 7. The introduction of deuterium into the A9-THC precursors can be done with Grignard reagents such as C[ H3]MgI or reducing substances such as LiAl[ H4]. The general procedures for the synthesis with these [ Hj-labeled precursors are the same as described above for the unlabeled compounds [76,78]. 

Whilst for the analysis of plant material for cannabinoids both GC and HPLC are commonly used, in analytical procedures the employment of GC-based methods prevails for human forensic samples. Nonetheless, the usage of HPLC becomes more and more of interest in this field especially in combination with MS [115-120]. Besides the usage of deuterated samples as internal standards Fisher et al. [121] describe the use of a dibrominated THC-COOH (see 7.5). The usage of Thermospray-MS and electrochemical detection provide good performance and can replace the still-used conventional UV detector. Another advantage in the employment of HPLC rather than GC could be the integration of SPE cartridges, which are needed for sample preparation in the HPLC-system. 

Zink et al. used a blend of polystyrene (hPS) and its deuterated counterpart (dPS), both of molecular weight 1.95 x 106 (abbreviated 1.95 M). The average volume fraction (4>dPS) of deuterated polystyrene was 30%. The polymers were dissolved in toluene and spin cast on thin silicon wafers (about 10 x 10 mm), the resulting film thickness being about 300 nm. The samples were annealed at 245°C for 8 days, and the measurement of the resulting depth profiles was conducted by NRA using a monoenergetic 700 keV 3He beam. The nuclear reaction employed can be written ... 

The application of deuterated ammonium formate as a deuterium source in transfer deuteration reactions of aromatic heterocycles has been reported by Derdau (Scheme 6.173 c) [329]. It was found that the reaction time could be reduced from 12-18 h (50 °C, oil bath) to 20 min at 80 °C by employing microwave irradiation, using deuteriomethanol as solvent and 10% palladium-on-charcoal as a catalyst. 

A stopped-flow methodology using deuterium exchange was employed to study the binding dynamics of 1 with ct-DNA.93 This method relies on the fact that the absorption spectrum of 1 changed upon deuteration, and the rate for deuteration was slowed down when 1 was bound to DNA when compared to the rate in aqueous solution. This method was validated by comparing the rate constant values with... 

Although the first NMR spectra of deuterated proteins were published already in 1968, the deuteration was mainly employed for the purpose of simplifying one-dimensional proton spectra.53,54 Later in the 1980s, LeMaster and co-workers employed random fractional deuteration for the assignment of thioredoxin using homonuclear two-dimensional spectroscopy.55 However, it was realized that deuteration significantly improves the spectral quality of homonuclear multidimensional NMR experiments. 

Ogashasa and Mataka [62] have employed crossed Kolbe electrolyses of deuterated phenylacetates and succinates to produced derivatives of 4-phenylbutyric acids. In control experiments to produce deuterated bibenzyls from phenylacetate without the presence of succinate, they obtained 11 % of dimer with pyridine present, under normal conditions, and 41 % of dimer with an ultrasonic cleaning bath. This increase in yield was ascribed to a sweeping clean of the electrode by ultrasound. 

The difference in the electron affinity between light and heavy isotopic isomers is, in other words, the difference in the stability of their anion-radicals. Such a difference gives a valuable tool for use in probing the chemistry of anion-radicals. The difference in the stability of the ring-deuterated and ring-nondeuterated arene anion-radicals has been employed to examine the transition states for the one-electron-promoted cleavage of naphthyl methyl phenyl ether and naphthyl benzyl ether (Guthrie and Shi 1990). In this reaction, the potassium salt of fluoranthene anion-radical was an electron donor ... 

An interesting application in porous silica glass employs deuterium spin-lattice relaxation rates in selectively deuterated pyridine (50). The pore-size dependence shown in Fig. 20 is linear in the reciprocal of the pore radius for both the para and ortho positions, but the significant difference in the relaxation at these two positions precludes analysis by an isotropic... 

---