Destructive sample preparation methods combustion method

The concentration of metals that are detrimental to catalysts added can vary between 20.0 ppm for Fe to 100 ppm for Ni and lOOOppm for V. The presence of these metals necessitates the need for analysis of these metals to determine their concentrations prior to the cracking process. The best method to analyse these oil samples needs to be rapid and accurate. Careful selection of the method either from experience or by trial and error may be applied depending on the metal and the concentration. Sample dissolution in a solvent or solvent mixture is considered the easiest but may not be suitable for low limits of detection. Destructive sample preparation methods, i.e. oxygen bomb combustion, microwave acid digestion followed by pre-concentrating may be required for trace analysis and/or with the aid of a hyphenated system, e.g. ultrasonic nebuliser. Samples prepared by destmctive methods are dissolved in aqueous solutions that have very low matrix and spectral interferences. 

Results. The slurry method of analysis of wear oils can give reproducible results when compared with the bomb combustion method (Table 5.19). The random selected metals analysed for this sample were used to show that this method could be used as an alternative provided that the particle sizes of insoluble suspensions in the oil are suitably small. This method may be an alternative to sample preparation by tedious destructive methods. 

Table 6.27 Results of analysis of polyurethane (PU) adhesives spiked with 0.1 % organometallic catalysts using destructive methods ashing, microwave acid digestion and bomb combustion methods of sample preparation...

The selectivity and sensitivity offered by atomic spectroscopy techniques can be used for direct and indirect determination of metals in a range of pharmaceutical preparations and compounds. Metals can be present in pharmaceutical preparations as a main ingredient, impurities, or as preservatives which can be prepared for analysis using non-destructive (direct or solvent dilution) or destructive methods (microwave acid digestion, bomb combustion, extraction, etc.) and the metal of interest measured against standards of the metal prepared in the same solvents as the sample. Methods associated with some pharmaceutical products are already described in the international pharmacopoeias and must be used in order to comply with regulations associated with these products, e.g titration techniques are carried out according to methods that are the same for all pharmaceutical products. 

---