Design region

Figure 2.42 shows the variability risks analysis based on the toleranees assigned to meet the 0.2 mm toleranee for the assembly. Given that an FMEA Severity Rating (S) = 5 has been determined, whieh relates to a definite return to manufaeturer , both impaet extruded eomponents are in the unaeeeptable design region, as well as the bobbin and plunger end seal as shown on the Conformability Matrix in Figure 2.43. The toleranee for the brass tube base thiekness has no risk and is an aeeeptable design.

Annual meteorological data from designated regional stations. 

To achieve the minimum cooling water flowrate target in design requires that the problem is decomposed into design regions, as illustrated in Figure 24.8. This shows... 

Fig. 10. Molecular and electronic structure of cation 74. (a) Perspective view on the cation 74. (b) Coordination sphere of the Pb atom, selected interatomic distances (pm) and angles (deg) Pb-(center CC, C7), 281.7 Pb-(center C6 CT), 280.7 Pbl-C2, 227(2) Pbl-C2 221.1(15) Pbl-C8, 231.0(19) C6-C7, 133(2) CC-CT 132(2) (center C6, C7)-Pb-(center C6, C7 163.6. (c) Contour plots of the Laplacian distribution [V p(r)] in the plane containing the atoms Pb, C6 and C7. Solid and dotted lines designate regions of local charge concentration and depletion, respectively. The bond paths are indicated by the solid back lines, bond critical points are marked with a black square. (Reprinted with permission from Ref. 53. Copyright 2003, Wiely-VCH.)...

Fig. 21. Types of magnetization curves corresponding to designated regions of the a-0 plane, according to Neel (471) collinear,...

Of course, the perceived importance of factors depends on the experimental domain or design region which is the experimental area to be explored and is also called the experimental frame by Zeigler et al. (2000). The clients must supply information about this domain to the simulation analysts, including realistic ranges of the individual factors and limits on the admissible scenarios or combinations of factor levels for example, in some applications the factor values must add up to 100%. 

Of the 14 formulations listed in Table 1, six experimental runs were required to fit the quadratic mixture model, four additional distinct runs were used to check for the lack of fit, and finally four runs were replicated to provide an estimate of pure error. Design-Expert used the vertices, the edge centers, the overall centroid, and one point located halfway between the overall centroid and one of the edge centers as candidate points. Additionally, four vertices of the design region were used as check points [106],... 

Designated Regional Coordinator Louisiana Region 7 Hospital Preparedness Director of Emergency Preparedness Louisiana Poison Center Shreveport, Louisiana... 

Some pharmaceutical companies have cdready designed Regional Packs for the Arab countries. The GCC countries fully appreciate such a pack. Undoubtedly, in the not too distant future, this will be a specified requirement. 

Deflection. Dynamic shaft deflection at the impeller centerline shall not exceed 0.005 in. (0.13 mm) anywhere within the design region as specified... 

Running Clearances. Running clearance must be sufficient to prevent internal rubbing contact witiiin the design region (para. 5.1.6) and is subjected to the maximum allowable flange loads as specified in para. 5.1.2. 

---