Cyclooctene stability

Cyclooctatetraene is relatively stable but lacks the special stability of benzene Unlike benzene which we saw has a heat of hydrogenation that is 152 kJ/mol (36 kcal/mol) less than three times the heat of hydrogenation of cyclohexene cycloocta tetraene s heat of hydrogenation is only 26 kJ/mol (6 kJ/mol) less than four times that of CIS cyclooctene... 

E-Cyclooctene is also significantly straine4 but less so than -cycloheptene. As the ring size is increased, the amount of strain decreases. The. E-isomers of both cyclononene and cyclodecene are less stable than the corresponding Z-isomers, but for cycloundecene and cyclododecene, the E-isomers are the more stable. Table 3.10 gives data concerning the relative stability of the C7 through C12 cycloalkenes. 

The hydrogenation activity of the isolated hydrides 3 and 6 towards cyclooctene or 1-octene was much lower than the Wilkinson s complex, [RhCKPPhj) ], under the same conditions [2] furthermore, isomerisation of the terminal to internal alkenes competed with the hydrogenation reaction. The reduced activity may be related to the high stability of the Rh(III) hydrides, while displacement of a coordinated NHC by alkene may lead to decomposition and Rh metal formation. 

The following conclusions can be drawn (a) ir-Allylnickel compounds are probably not involved in the catalytic dimerization of cyclooctene, because the highest reaction rate occurs when only traces of these compounds can be detected further, the concentration of the new 7r-allyl-nickel compound (19) becomes significant only after the catalytic reaction has ceased, (b) The complex formed between the original 7r-allylnickel compound (11) and the Lewis acid is transformed immediately upon addition of cyclooctene to the catalytically active nickel complex or complexes. In contrast to 7r-allylnickel compounds, this species decomposes to give metallic nickel on treatment of the catalyst solution with ammonia, (c) The transformation of the catalytically active nickel complex to the more stable 7r-allylnickel complex occurs parallel with the catalytic dimerization reaction. This process is obviously of importance in stabilizing the catalyst system in the absence of reactive olefins. In... 

Recently, Liew et al. reported the use of chitosan-stabilized Pt and Pd colloidal particles as catalysts for olefin hydrogenation [51]. The nanocatalysts with a diameter ca. 2 nm were produced from PdCl2 and K2PtCl4 upon reduction with sodium borohydride in the presence of chitosan, a commercial biopolymer, under various molar ratios. These colloids were used for the hydrogenation of oct-1-ene and cyclooctene in methanol at atmospheric pressure and 30 °C. The catalytic activities in term of turnover frequency (TOF mol. product mol. metal-1 h-1)... 

Figure 3.12 Durability of colloidal Pd/C catalysts in the cyclooctene hydrogenation test compared with a conventional Pd/C system. (Adapted from Bonnemann, H. and Brijoux, W., in Surfactant-Stabilized Nanosized Colloidal Metals and Alloys as Catalyst Precursors/Advanced Catalysts and Nanostructured Materials, Moser, W., Ed., Academic Press, San Diego, 1996, pp. 165-196, Chap. 7. With permission from Elsevier Science.)...

A new class of heterogeneous catalyst has emerged from the incorporation of mono- and bimetallic nanocolloids in the mesopores of MCM-41 or via the entrapment of pro-prepared colloidal metal in sol-gel materials [170-172], Noble metal nanoparticles containing Mex-MCM-41 were synthesized using surfactant stabilized palladium, iridium, and rhodium nanoparticles in the synthesis gel. The materials were characterized by a number of physical methods, showed that the nanoparticles were present inside the pores of MCM-41. They were found to be active catalysts in the hydrogenation of cyclic olefins such as cyclohexene, cyclooctene, cyclododecene, and... 

It appears that oxiranes known to give predominantly a-deprotonation in basic media (cyclopentene, cyclooctene and exo-norbomene oxide) are also the more strained (Table 1 entries 3, 6, 7). On the other hand, oxiranes that give mainly -deprotonation (butene, cyclohexene oxide) have lower strain energies and higher a-anion stabilities (Table 1 ... 

Ebenso ist seit langem trans-Cycloocten als relativ stabile, isolier-bare Verbindung bekannt (70). 

Introduction of the allene structure into cycloalkanes such as in 1,2-cyclononadiene (727) provides another approach to chiral cycloalkenes of sufficient enantiomeric stability. Although 127 has to be classified as an axial chiral compound like other C2-allenes it is included in this survey because of its obvious relation to ( )-cyclooctene as also can be seen from chemical correlations vide infra). Racemic 127 was resolved either through diastereomeric platinum complexes 143) or by ring enlargement via the dibromocarbene adduct 128 of optically active (J3)-cyclooctene (see 4.2) with methyllithium 143) — a method already used for the preparation of racemic 127. The first method afforded a product of 44 % enantiomeric purity whereas 127 obtained from ( )-cyclooctene had a rotation [a]D of 170-175°. The chirality of 127 was established by correlation with (+)(S)-( )-cyclooctene which in a stereoselective reaction with dibromocarbene afforded (—)-dibromo-trans-bicyclo[6.1 0]nonane 128) 144). Its absolute stereochemistry was determined by the Thyvoet-method as (1R, 87 ) and served as a key intermediate for the correlation with 727 ring expansion induced... 

It has been suggested [95] that the synthesis of structured porphyrins with controllable steric ambience is a strategic direction in the reproduction of enzyme protein cavities, which control the selectivity and stability of biochemical reactions such as cytochrome P-450. Such an approach to the synthesis of biomimics has considerable potential, especially in their application on mineral matrices silicon dioxide, alumina and zeolites. Data exist on the synthesis of a biomimic [96] with a complex porphyrin complex (5-pentafluorophenyl-10,15,20-tri(2,6-dichlorophenyl)porphyrin (FeMPFDCPP)) covalently linked to aminopropyl silicon dioxide, which is applied in oxidation of ds-cyclooctene, cyclohexene, cyclohexane and adamantane with participation of iodosylbenzene dissolved in dichloromethane. 

Another method of MPFDCPP catalyst synthesis, applied in this work, was borrowed from Ref. [97], All these catalysts displayed extremely high stability. Nevertheless, a large number of catalytic cycles was observed only at cyclooctene epoxidation. Thus, these... 

---