Crystals differential scanning calorimetry

Peripheral modification of the receptor molecules may allow the existence of stacking structures in soft materials such as thermotropic liquid crystals. Differential scanning calorimetry (DSC) analysis of the octane xerogel of Ic Cl -TATA+ suggested the formation of a mesophase as observed in the phase transitions at 88 and 42°C upon first cooling from the isotropic liquid state (Iso) and at 44 and 96°C upon second heating. 

The crystal stmcture of glycerides may be unambiguously determined by x-ray diffraction of powdered samples. However, the dynamic crystallization may also be readily studied by differential scanning calorimetry (dsc). Crystallization, remelting, and recrystallization to a more stable form may be observed when Hquid fat is solidified at a carefully controlled rate ia the iastmment. Enthalpy values and melting poiats for the various crystal forms are shown ia Table 3 (52). 

Fig. 10. Differential scanning calorimetry of cellulose triacetate. Second heating at 20°C/min. glass-transition (T temperature = 177 " C crystallization on heating (T)/j) = 217 C melting temperature (Ta) = 289 C. To convert to cal, divide by 4.184.

Many papers deal with the crystallization of polymer melts and solutions under the conditions of molecular orientation achieved by the methods described above. Various physical methods have been used in these investigations electron microscopy, X-ray diffraction, birefringence, differential scanning calorimetry, etc. As a result, the properties of these systems have been described in detail and definite conclusions concerning their structure have been drawn (e.g.4 13 19,39,52)). 

Triethanolamine salts of alcohol sulfates form white crystals when obtained in pure form after recrystallization. At their melting point they are semisolid with gelatinous appearance and the transition is difficult to detect. Melting points, determined through thermograms obtained by differential scanning calorimetry, gave 72, 76, 80, and 86°C for dodecyl, tetradecyl, hexadecyl, and octadecyl sulfates, respectively [63]. 

KNUDSEN J c, ANTANUSE H s, RisBO j and SKIBSTED L H (2002) Induction time and kinetics of crystallization of amorphous lactose, infant formula and whole milk powder as studied by isothermal differential scanning calorimetry, Milchwissenschaft, 57, 543-546. 

Birefringence measurements have been shown to be very sensitive to bimodality, and have therefore also been used to characterize non-Gaussian effects resulting from it in PDMS bimodal elastomers [5,123]. The freezing points of solvents absorbed into bimodal networks are also of interest since solvent molecules constrained to small volumes form only relatively small crystallites upon crystallization, and therefore exhibit lower crystallization temperatures [124—126]. Some differential scanning calorimetry (DSC) measurements on... 

Rytter et al. reported polymerizations with the dual precatalyst system 14/15 in presence of MAO [30]. Under ethylene-hexene copolymerization conditions, 14/MAO produced a polymer with 0.7 mol% hexene, while the 15/MAO gave a copolymer with ca. 5 mol% hexene. In the mixed catalyst system, the activity and comonomer incorporation were approximate averages of what would be expected for the two catalysts. Using crystallization analysis fractionation (CRYSTAF) and differential scanning calorimetry (DSC) analysis, it was concluded in a later paper by Rytter that the material was a blend containing no block copolymer [31],... 

Levine and Slade [1.16] investigated the mechanics of cryostability by carbohydrates. Figure 1.19.1 shows an idealized phase diagram developed from differential scanning calorimetry (DSC) measurements for hydrolyzed starch (MW > 100) and for polyhydroxy combinations having a small molecular mass. With slow cooling (quasi in equilibrium conditions), no water crystallizes below the Tg curve. 

The preparation of immiscible polymer blends is another way to disperse a bulk polymer into fine droplets. It has been reported for several polymers that when they are dispersed in immiscible matrices into droplets with average sizes of around 1 pm, they usually exhibit multiple crystallization exotherms in a differential scanning calorimetry (DSC) cooling scan from the melt (at a specific rate, e.g., 10 Cmin ). Frensch et al. [67] coined the term fractionated crystallization to indicate the difference exhibited by the bulk polymer, which crystallizes into a single exotherm, in comparison with one dispersed in a large number of droplets, whose crystallization is fractionated temperature-wise during cooling from the melt. 

The results of differential scanning calorimetry(DSC) indicate the change in aggregation state. The trans micelle showed a main endothermic peak at 14 2°C(A H =1.0 kcal/mol), corresponding to a gel-liquid crystal phase transition, whereas the transition temperature for the cis micelle appeared at 11.9°C( AH = 0.8 kcal/mol). This is unequivocal evidence that the trans-cis photoisomerization is a sufficient perturbation to alter the state of molecular aggregation. 

---