Core strength

Films may be applied for identification, to improve core strength, aesthetics, taste masking, enteric release, stability (protection from environment), or to provide sustained or controlled release. For many products, development of latex coating materials has eliminated the safety hazards and emissions problems related to the use of organic solvents. 

Managed care pharmacists have identified the following core strengths that pharmacists should have to enable them to thrive in a managed care setting. Pharmacists should ... 

Nylon 6 is susceptible to UV damage, but the sheath, which contains UV stabilisers, protects the rope core. Some colours of the sheath begin to fade before the impact performance severely deteriorates. Dirt would reduce the core strength if it could penetrate the sheath. Fine particles of rock would get among the fibres of the core, then abrade and fracture them when the rope was flexed. 

As with TIMS, the core strength of MC-ICP-MS is its ability to register ion signals simultaneously. However, the traditional calibration approaches use sequential analysis of the measurand and the calibrant as a result of their temporally different introduction into the source. Hence a paradox of the choice in contrast to sequential measurand-ratios measured simultaneously. This, however, can only be done when the calibrator is a ratio of isotopes other than the measurand, which, in turn, requires a sound model for the mass bias transfer. 

Basu s model (2004, p. 270) as shown in Figure 6.1 provides a useful framework in make or but decisions. The model shown below uses the core strength... 

High technology/high volume These products are suitable for own manufacturing. It will be appropriate to invest to retain the core strength. 

Table 1.15 gives a selection composition and comparison possibilities of the different materials. Due to the high core strength, it is now possible to move forward into new application areas. 

FIGURE 3.10 Core Strength of case-hardening steels 1.2162 and 1.2767 as a function of diameter and quenching process... 

---