Continuously Stirred Tank Reactor..See CSTR

Conservation of mass, see Mass Conservation of sites, 242 Constant density, 136 Continuous-stirred-tank reactor, see CSTR... 

Continuous-stirred-tank-reactor system, 11 198-199, 204. See also CSTR reactor system... 

CSTR reactor system, 23 396. See also Continuous- stirred tank reactor (CSTR) anionic polymerization C-toxiferine, 2 74, 99 C-type inks, 14 324, 326 C-type natriuretic peptide (CNP), 5 186-187... 

In the following we attempt to describe the acetylcholinesterase/choline acetyltransferase enzyme system inside the neural synaptic cleft in a simple fashion see Figure 4.49. The complete neurocycle of the acetylcholine as a neurotransmitter is simulated in our model as a simple two-enzymes/two-compartments model. Each compartment is described as a constant-flow, constant-volume, isothermal, continuous stirred tank reactor (CSTR). The two compartments (I) and (II) are separated by a nonselective permeable membrane as shown in Figure 4.50. 

This expression enhances the fact that the heat release rate is a function of the conversion and will therefore vary with time in discontinuous reactors or during storage. In a batch reaction, there is no steady state. It is constant in the Continuous Stirred Tank Reactor (CSTR) and is a function of the location in the tubular reactor (see Chapter 8). The heat release rate is... 

We have used CO oxidation on Pt to illustrate the evolution of models applied to interpret critical effects in catalytic oxidation reactions. All the above models use concepts concerning the complex detailed mechanism. But, as has been shown previously, critical. effects in oxidation reactions were studied as early as the 1930s. For their interpretation primary attention is paid to the interaction of kinetic dependences with the heat-and-mass transfer law [146], It is likely that in these cases there is still more variety in dynamic behaviour than when we deal with purely kinetic factors. A theory for the non-isothermal continuous stirred tank reactor for first-order reactions was suggested in refs. 152-155. The dynamics of CO oxidation in non-isothermal, in particular adiabatic, reactors has been studied [77-80, 155]. A sufficiently complex dynamic behaviour is also observed in isothermal reactors for CO oxidation by taking into account the diffusion both in pores [71, 147-149] and on the surfaces of catalyst [201, 202]. The simplest model accounting for the combination of kinetic and transport processes is an isothermal continuously stirred tank reactor (CSTR). It was Matsuura and Kato [157] who first showed that if the kinetic curve has a maximum peak (this curve is also obtained for CO oxidation [158]), then the isothermal CSTR can have several steady states (see also ref. 203). Recently several authors [3, 76, 118, 156, 159, 160] have applied CSTR models corresponding to the detailed mechanism of catalytic reactions. 

Continuous stirred-tank reactors (CSTRs, see Figure 3.4) have the advantage over batch reactors that they are easier to keep at constant temperature. This is because they do not see the high initial reaction rate of batch reactors, and because continuous flow into and out of the reactor helps to consume or supply heat. For example, if the reaction is highly exothermic, the entering fluid may be introduced at a temperature below that of the reactor, so that it consumes heat as it is heated up. Another advantage is that samples can be taken from the effluent rather than... 

Reactors used in ethylene polymerizations range from simple autoclaves and steel piping to continuous stirred tank reactors (CSTR) and vertical fluidized beds. Since the 1990s, a trend has emerged wherein combinations of processes are used with transition metal catalysts. These combinations allow manufacturers to produce polyethylene with bimodal or broadened molecular weight distributions (see section 7.6). 

The above endothermic reaction takes place in two continuous stirred tank reactors (CSTRs) in series, and the heat required by the reaction is supplied by steam (see... 

---