Conic vortex generator

Dynamic gas washer, according to Figures 7.1 and 7.2, contains the vertical cylindrical case with the bunker gathering slime, branch pipes of input and an output gas streams. Inside of the case it is installed conic vortex generator, containing. 

Centrifugal Dedusters with Conic Vortex Generator T5 e... 

CENTRIFUGAL DEDUSTERS WITH CONIC VORTEX GENERATOR TYPE ATVP AND ATVC... 

Hydraulic characteristics conic vortex generator type ATVP are most full investigated researched by development high-economical direct-flow cyclones (Kouzov, 1972 and Adamar, 1970). 

The increase in height vortex generator at constant values does not influence on The factor of hydraulic resistance of devices with conic vortex generator... 

For dednsters with conic vortex generator (Adamar, 1970) equation is offered... 

Inside of the case, it is established installed conic vortex generator 5, containing... 

At rotation of a rotor 12, liquid takes a great interest in blades vortex generator 5, moistens their surface and is sprayed in the form of fine drops on a way of movement of cleared gases that provides high-intensity contact of phases outside of conic vortex generator 5 and raises increases efficiency of clearing of gas. 

FIGURE 15.3 Combined vortex generator (a)-conic (6)-tangential-curvilinear, (b)-... 

For a supply of a liquid in a zone of contact, it is offered to use hollow blades axial, conic, or tangential vortex generator [12002D19]. But, they are complex difficult in manufacturing and reduce relative section vortex generator that limits area of their application. Diameter and height of contact branch pipes essentially influence metal consumption of the device and efficiency mass transfer. For an intensification mass transfer in a number of designs (wed), it is offered to put render on a surface... 

The ring top basis 6 and conic dissector 7, placed on the bottom basis 8 vortex generator 5. The bases 6 and 8 are rigidly connected with each other by means of the unidirectional blades 9. 

Before vortex generator 5, the axial branch pipe 10 supplies of a liquid is placed, at a level top cut, which the basis conic dissector 7 is located with a backlash. On an output exit of a gas stream are stipulated drip pan 11. Vortex generator 5, it is fixed on a rotor 12, which is resulted brought in rotation by the electric motor through a belt drive 13. 

---