Compounds of transition metals

III. Catalysts Based on the Use of Organometallic Compounds of Transition Metals. 184... 

In essence the active centers for catalytic polymerization of olefins are organometallic complexes of transition metals. For this reason a search for individual organometallic compounds that would possess catalytic activity in olefin polymerization is of great interest. The first attempts to use organometallic compounds of transition metals as catalysts for olefin polymerization were made long ago [e.g. CH3TiCl3 as a catalyst for polymerization of ethylene 116). However, only in recent years as a result of the application of relatively stable organometallic compounds of transition... 

In Ballard et al. (9a, 118, 123) the formation of the propagation centers from benzyl and allyl compounds of transition metals were supposed to be a result of the insertion of the monomer into the bond between the organic ligand and metal in the initial compound according to the following schemes ... 

B. Catalysts Formed by Interaction of Organometallic Compounds of Transition Metals with Oxide Supports... 

Recently some information became available on a new type of highly active one-component ethylene polymerization catalyst. This catalyst is prepared by supporting organometallic compounds of transition metals containing different types of organic ligands [e.g. benzyl compounds of titanium and zirconium 9a, 132), 7r-allyl compounds of various transition metals 8, 9a, 133), 7r-arene 134, 185) and 71-cyclopentadienyl 9, 136) complexes of chromium]. 

The formation of surface defects of a crystal lattice. It was observed while using crystal compounds of transition metals as catalysts [e.g. as was shown by Arlman (171, 173), for a TiCl3 surface defects appear on the lateral faces of the crystal]. In this case low surface concentration of the propagation centers should be expected, as is illustrated in the case of polymerization by titanium dichloride (158). The observed... 

With regard to the mechanism of these Pd°-catalyzed reactions, little is known in addition to what is shown in Scheme 10-62. In our opinion, the much higher yields with diazonium tetrafluoroborates compared with the chlorides and bromides, and the low yields and diazo tar formation in the one-pot method using arylamines and tert-butyl nitrites (Kikukawa et al., 1981 a) indicate a heterolytic mechanism for reactions under optimal conditions. The arylpalladium compound is probably a tetra-fluoroborate salt of the cation Ar-Pd+, which dissociates into Ar+ +Pd° before or after addition to the alkene. An aryldiazenido complex of Pd(PPh3)3 (10.25) was obtained together with its dediazoniation product, the corresponding arylpalladium complex 10.26, in the reaction of Scheme 10-64 by Yamashita et al. (1980). Aryldiazenido complexes with compounds of transition metals other than Pd are discussed in the context of metal complexes with diazo compounds (Zollinger, 1995, Sec. 10.1). 

Nitric oxide compounds of transition metals. B. F. G. Johnson and J. A. McCleverty, Prog. Inorg. Chem., 1966,7, 277-359 (264). 

The structure of cluster compounds of transition metals and the limits of applicability of the electron counting rules forpolyhedral molecules. Y. L. Slovokhotov and Y. T. Struchkov, Russ. Chem. Rev. (Engl. Transl), 1985, 54, 323 (150). 

Pauling, L. (1975) Valence-bond theory of compounds of transition metals, Proc. Natl. Acad. Sci. USA 72,4200-4202. 

Peroxy Compounds of Transition Metals J. A. Connor and E. A. V. Ebsworth The Direct Synthesis of Organosilicon Compounds J. J. Zuckerman... 

Although naturally occurring compounds of transition metals are restricted in scope, a wide variety of compounds can be synthesized in the laboratory. Representative compounds appear in Table 20-2. These compounds fall into three general categories There are many binary halides and oxides in a range of oxidation numbers. Ionic compounds containing transition metal cations and polyatomic oxoanions also are common these include nitrates, carbonates, sulfates, phosphates, and perchlorates. Finally, there are numerous ionic compounds in which the transition metal is part of an oxoanion. 

According to the preceding statements certain coordination polyhedra occur preferentially for compounds of transition metals, depending on the central atom, the oxidation state, and the kind of ligand. The general tendencies can be summarized as follows ... 

Kuzmina and Struchkov 37) reported the structure of some organic compounds of transition metals, including triphenylstannyl derivatives of 2-dimethylamino-... 

IP Skibida. Homogeneous Catalysis by Compounds of Transition Metals in Liquid-Phase Oxidation by Molecular Oxygen. Doctoral Thesis Dissertation. RUDN, Moscow, 1997. 

Compounds of transition metals (Mn, Cu, Fe, Co, Ce) are well known as catalysts for the oxidation of hydrocarbons and aldehydes (see Chapter 10). They accelerate oxidation by destroying hydroperoxides and initiating the formation of free radicals. Salts and complexes containing transition metals in a lower-valence state react rapidly with peroxyl radicals and so when these compounds are added to a hydrocarbon prior to its oxidation an induction period arises [48]. Chain termination occurs stoichiometrically (f 1) and stops when the metal passes to a higher-valence state due to oxidation. On the addition of an initiator or hydroperoxide, the induction period disappears. 

The development of G. N. Lewis s octet rule for the s/p-block elements was strongly influenced by the stoichiometric ratios of atoms found in the common compounds and elemental forms (CH4, CCI4, CO2, CI2, etc.). Let us therefore begin analogously by examining the formulas of the common neutral binary chloride, oxide, and alkyl compounds of transition metals. (Here we substitute alkyl groups for hydrogen because only a small number of binary metal hydrides have been well characterized.)... 

The importance of scalar relativistic effects for compounds of transition metals and/or heavy main group elements is well established by now [44], Somewhat surprisingly (at first sight), they may have nontrivial contributions to the TAE of first-row and second-row systems as well, in particular if several polar bonds to a group VI or VII element are involved. For instance, in BF3, S03) and SiF4, scalar relativistic effects reduce TAE by 0.7, 1.2, and 1.9kcal/mol, respectively - quantities which clearly matter even if only chemical accuracy is sought. Likewise, in a benchmark study on the electron affinities of the first-and second-row atoms [45] - where we were able to reproduce the experimental values to... 

The following type of reaction may serve as an example for the formation of complex compounds of transition metal elements ... 

---