Chloride adsorption variability

The hydration of polyoxyethylene (POE) is dramatically affected by the anion present(J 0) in the aqueous phase. The adsorption of HEC (both 2.0 and 4.3 M.S.) was therefore studied in Na SO and Na PO, at equivalent normalities. The multivalent anions are more effective in precipitating POE than is the chloride ion. The amounts adsorbed and the interlayer expansions at normalities below precipitation conditions are given in Table III. The influence of multivalent anions on the intrinsic viscosity of variable M.S. HECs is illustrated in Figure 6. The increased amounts adsorbed are within experimental error, but the decrease in d. with the 4.3 M.S. HEC is notable. The d. changes in the absence of increased adsorption are not explainable in terms of solvation effects. 

Due to its ability to withstand high pressure, its relative low cost, and inertness, stainless steel has become the standard material of columns and other chromatographic components. However, under certain circumstances, stainless steel has been shown to interact with the sample and the mobile phase [39]. The best known example is chloride salt corrosion of stainless steel. Data indicate that nearly all common eluents dissolve iron from stainless steel [39]. It appears that proteins also adsorb to stainless steel [39], The adsorption process is fast, whereas desorption is slow, a result which leads to variable protein recoveries. A number of manufacturers are offering alternatives to stainless components with Teflon -lined columns and Teflon frits. Titanium is being explored as an alternative to stainless steel. A cheaper and simpler procedure is to oxidize the surface of the stainless steel with 6N nitric acid. This procedure should be repeated about every 6 months. 

Unlike that of normal molecules, the composition of the particles in an association colloid is not perfectly defined. Composition is variable from one solution to another and depends on the preparation method. In water at least, there is a single sodium chloride, whereas there may be a whole series of ferric phosphates with dimensions varying from 1 to 10. Furthermore, the ions present in the solution are fixed to variable degrees by adsorption at the interfaces. The components of macromolecular colloids, however, are less variable. 

---