Catalysts alkylene oxide polymerisation

Polyether Polyols. Polyether polyols are addition products derived from cyclic ethers (Table 4). The alkylene oxide polymerisation is usually initiated by alkah hydroxides, especially potassium hydroxide. In the base-catalysed polymerisation of propylene oxide, some rearrangement occurs to give aHyl alcohol. Further reaction of aHyl alcohol with propylene oxide produces a monofunctional alcohol. Therefore, polyether polyols derived from propylene oxide are not truly diftmctional. By using sine hexacyano cobaltate as catalyst, a more diftmctional polyol is obtained (20). Olin has introduced the diftmctional polyether polyols under the trade name POLY-L. Trichlorobutylene oxide-derived polyether polyols are useful as reactive fire retardants. Poly(tetramethylene glycol) (PTMG) is produced in the acid-catalysed homopolymerisation of tetrahydrofuran. Copolymers derived from tetrahydrofuran and ethylene oxide are also produced. 

The catalysts used for alkylene oxide polymerisation, initiated by hydroxyl groups, are ... 

Unfortunately, DMC catalysts are not efficient for EO polymerisation, and it is practically impossible to obtain PO-EO block copolymers with this catalyst. Acidic catalysts are not used on an industrial scale for alkylene oxide polymerisation due to the formation of substantial amounts of cyclic ethers as side products. Acidic catalysts are used industrially only for the synthesis of polytetrahydrofuran polyols or, to a lesser extent, for tetrahydrofuran - alkylene oxide copolyether polyol fabrication (see Sections 7.1, 7.2 and 7.3) Other catalysts have a minor importance for large scale polyether polyol production. 

The alkylene oxide polymerisation, catalysed by DMC catalysts, is characterised by some specific points ... 

An important characteristic of alkylene oxide polymerisation with DMC catalysts is the very low reaction rates obtained in EO coordinative polymerisation. EO, which is much more reactive than PO in anionic polymerisation, is less reactive than PO in the coordinative polymerisation [35, 68]. A possible explanation of this behaviour is the fact that PO is a more basic monomer than EO due to the electron release effect of the methyl substituent in the oxiranic ring (the electron density at the oxygen atom of the PO ring is higher than that in the EO ring). As an immediate consequence, PO, is more basic, and is more strongly co-ordinated (and more strongly activated too) to the active sites of DMC catalysts than EO, the less basic monomer. 

Catalysts for the polymerisation of alkylene oxides initiated by hydroxyl groups must have some general and very important qualities ... 

In the history of PU, some continuous processes for polyether polyol synthesis by anionic polymerisation were developed, but only at small scale (i.e., pilot plant). Tubular reactors with static mixing systems or a column with plate reactor types were used, but these technologies were not extended to industrial scale levels. The first continuous process for high MW polyether synthesis was developed by Bayer (IMPACT Technology) and is based on the very rapid coordinative polymerisation of alkylene oxides, especially PO, with dimetallic catalysts (DMC catalysts - see Chapter 5). A principle technological scheme of a polyether polyol fabrication plant is presented in Figure 4.30. 

Copolymerisation of propylene oxide as well as other oxiranes with carbon dioxide in the presence of zinc-based coordination catalysts is generally accompanied with the formation of a cyclic five-membered carbonate, propylene carbonate or another alkylene carbonate [147,206,207,210,212,230]. The alky-lene carbonate, however, is not the precursor for poly(alkylene carbonate), since it hardly undergoes a polymerisation under the given conditions [142-146],... 

---